Filter
Top Products
62
1
2
3
1
2
DVD
RCVR / VCR
T V
CBL / SAT
MODE
--
/
---
SEND / LEARN
TOP MENU MENU
RETURN
ON SCREEN
CH CH
VOLUME
UP
DOWN
TV / VCR
S
T
A
N
D
B
Y
/
O
N
E
N
T
E
R
LIGHT
DVD
RCVR / VCR
T V
CBL / SAT
INPUT
DIMMER
SLEEP
MASTER
VOLUME
PRESET
123
456
789
MEM CLR
0
R
E
P
E
A
T
A
-
B
R
A
N
D
O
M
M
U
T
I
N
G
ENTER
PLAYPLAY
SP A SP B
FM MODE
SURROUND
SP SETUP
IPM
ACOUSTIC
CONTROL
LATE
NIGHT
AUDIOANGLE
SUBTITLE
ZOOM
SW MODE
T.TONE CH SEL
DISTANCE
PRGV DISCSLOW STEP
RC-
504
M
MODE
–
+
ENTER
SEND/LEARN
indicator
MODE buttons
DVD
RCVR / VCR
T V
CBL / SAT
MODE
ENTER
ENTER
Controlling other components connected to
the DVD Changer Receiver
Erasing all the commands
programmed under a MODE button
Press and hold down the desired
MODE button, press the ENTER
button twice, and then release both
buttons.
When you press the
MODE
button, the
SEND/LEARN indicator lights. When you
press the ENTER button, the lamp turns off.
When you release the buttons, the lamp
lights again.
Press and release the same MODE
button again.
When you release the button, the SEND/
LEARN indicator flashes twice slowly.
This erases all the commands
memorized to the MODE button.
Notes
• If no button is pressed for more than 30 seconds during the
erasing procedure, the remote controller exits the erasing mode.
Resume from Step 1.
• If you perform an invalid operation during erasing, the SEND/
LEARN indicator flashes three times quickly, and the remote
controller exits the erasing mode. Resume from Step 1.
• If many commands have been programmed to the MODE button,
then the SEND/LEARN indicator may remain lit for up to 20
seconds during Step 2. This is not a malfunction.
Erasing the programmed command
from one button
You can only erase memorized commands and not preset ones.
Press and hold down the desired
MODE button for the command,
press the ENTER button, and then
release both buttons.
When you press the MODE button, the
SEND/LEARN indicator lights. When you
press the ENTER button, the lamp turns
off. When you release the buttons, the
lamp lights again.
Press and release the button for the
command you wish to erase.
When you press the button, the SEND/
LEARN indicator turns off. When you
release the button, the lamp lights
again.
Press and release the same button
again.
The SEND/LEARN indicator flashes twice
slowly. The memorized command is
erased.
Note
• If no button is pressed for more than 30 seconds during the
erasing procedure, the remote controller exits the erasing mode.
Resume from Step 1.