Filter
Top Products
61
Notes:
• The remote controller has 220 memory slots (4 modes x 55
buttons). Some remote controllers may have more commands
that can be remembered by the remote controller. In such cases,
it will be necessary for you to determine which commands are
more important than others. (According to the type of the remote
controller, 220 commands cannot be programmed.)
• If no button is pressed for more than 30 seconds during the
programming, or if you perform an invalid operation during
programming, the remote controller exits the programming mode.
Resume from Step 2.
• If a failure occurs during programming, the SEND/LEARN
indicator flashes three times quickly. Resume from Step 3.
• If a failure occurs five times in row during programming, the
remote controller exits the programming mode. Resume from
Step 3.
• If you try to program beyond the learning capacity of the remote
controller, the SEND/LEARN indicator flashes three times quickly.
• When you want to program a command to a button to which you
have already programmed a command, simply follow the same
procedure given and programming for that button will be
overwritten.
• The remote controller uses infrared rays to send its
commands, as do most other remote controllers. Though
most remote controller codes can be memorized by the
remote controller, be aware that some remote controllers use
a system that is quite different from the remote controller
and therefore may not be able to be programmed.
• Some remote controllers have a single button that performs
multiple functions (for example, the function may change
each time the button is pressed). If this is the case, each
function must be programmed to a separate button on the
remote controller.
• Once you have transferred the commands from the other
remote controller, refer to the instruction manual that came
with that product for instructions on how to operate that
product.
• Make sure both the remote controller and the other remote
controller have new batteries. If either of them has batteries
that are low, you may not be able to program the commands
of the other remote controller properly into the remote
controller.
See page 62 for how to erase the memorized commands from
all buttons.
Press and hold down the button
(that corresponds to the command
you are programming) on the
remote controller of the other
device until the SEND/LEARN
indicator on the remote controller
flashes twice.
After flashing twice, the SEND/LEARN
indicator will light again.
Repeat Steps 3 and 4 to transfer all
the commands you desire from the
other remote controller and
program them to buttons on the
remote controller under the same
MODE.
Repeat steps 2 through 4 to program
commands to a different MODE (e.g.,
when programming from a different
remote controller).
Press the MODE button that you
pressed in step 2 to complete the
programming.
Operate the newly programmed
buttons to make sure the learning
function was performed properly.
6
DVD
RCVR / VCR
T V
CBL / SAT
MODE
5
4
7