Filter
Top Products
MULTI CONTROL
12.6.6 C75 (OFF
(OFF) = NX2 compass
If you want to use a NM EA input, you have to
set C75 to On. The Server will then transmit this information on the Nexus Network
to all connected instrum
After you have changed
12.6.7 C76 (OFF WND
(OFF) = NX2 wind trans
If you want to use a NM
set C76 to On. The Ser
to all connected instrum
After you have changed
12.6.8 C77 to C92
Contains 16 NMEA slot
12.6.9 C93 (d4 N
Damping for NMEA OU
Only compass heading (HT speed through water
(BSP) can be damped w th th
d0 = 0.5 sec, d2 =1 sec
d6 = 20 sec, d7 = .40 se
12.6.10 C94 (OFF
Select type of heading transducer, compass or navigator (COG),
to be displayed as main-function under NAVIGATE.
When COG is available (NX2 or NMEA), and no compass
transducer is connected, you can set C94 to (ON), COG will also
be used to compute TWD (true wind direction)
12.6.11 C95 (OFF SOG)
Select speed transducer to be displayed as main-function under SPEED.
(OFF) = Boat speed through the water from log transducer.
(ON) = Speed Over Ground (SOG) from navigator. This will not affect wind calculation,
see 12.6.12
12.6.12 C96 (REF BSP)
Select speed transducer (REF BSP) or Speed Over Ground (REF SOG) to be used for
computing true wind speed and angle, VMG, True Wind Direction and trip log, total log
and distance.
(REF BSP) = Boat speed through the water from log transducer.
(REF SOG) = Speed Over Ground (SOG) from navigator.
CMP)
transducer. (On) = NMEA compass transducer.
EA transducer (connected to the NM
ents.
this setting, you have to restart the system
)
ducer. (On) = NMEA wind transducer.
EA transducer (connected to the NMEA input, you have to
ver will then transmit this information on the Nexus Network
ents.
this setting, you have to restart the system
s. (See 12.7.2)
ME)
T from Server.
/HM) and boat
i is code.
, d3 = 2.5 sec, d4 = 5 sec, d5 = 10 sec,
c, d8 = 80 sec and d9 = 160 sec.
COG)
48