Filter
Top Products
MULTI CONTROL
15
3 First start
3.1 Initialising the instrument
At power on, the instrument will perform a self test. The display
will first show all segme
the Nexus Network ID n
At first power on after in SET
(PrESkey). This will give e instrument a logical ID number on the
Nexus Network.
To initialise the instrume re
instruments, one at the
Note: Always wait for
to be displayed, befor
er in SET
(PrESkey). This will give e instrument a logical ID number on the
Nexus Network.
To initialise the instrume re
instruments, one at the
Note: Always wait for
to be displayed, befor
nts, then the software version number and
umber.
stallation, you will be asked to press stallation, you will be asked to press
th th
nt, p ss SET on all installed digital nt, p ss SET on all installed digital
time. time.
the text ”Init OK”
e
the text ”Init OK”
e
you press SET
on the next instrumen
The Server automatical the first unit ID number 16, then
17 and so on. The ord
order as the instrument
Nexus Network.
The example shows that the instrument version number is 2.0 and
the given logical ID number is 16.
3.2 Re-initialising the instrument
If two instruments by mistake have the same ID number, this can
cause disturbance and block the information on the Nexus data
bus.
To re-initialise the instrument, press CLEAR during the power up
sequence when version and ID numbers are displayed.
The display self test is then re-started on all instruments and you
will be asked to press KEY on each instrument as explained
above.
Note! If you do not succeed to re-initialise, we suggest you
disconnect all but one instrument with the same ID number, then
repeat the above procedure.
t!
ly gives
er in which you press SET is the same
s will be given a logical ID number on the