Nexus 21 Multi Control Stereo Receiver User Manual


 
MULTI CONTROL
(Available for analogue
12.3.11 C40 (OFF
(Available from Multi ve
(ON) = All headings and
(OFF) = All headings an be true.
Note a: In the (Goto W ) function, the bearing for every leg will
always be displayed as tru
Note b: The setting is only a
instrument in which is set.
12.3.12 C41 DAM
Damping of compass he
Controls the response ti
To change damping, press SET.
To select damping level
d0 (Min) to d9 (max).
To store the value, pres
Default value is (d0), for use in calm sea. But if the sea is rough,
you may want to ”stabili
(d1) to (d9).
Note! Damping is set se each instrument.
12.4 Compass c
12.4.1 Automatic compass deviation compensation (Auto
DEV)
(Auto DEV) is performed by driving the boat in a circle up to 1¼
turn, so that the magnetic deviation can be measured, and by that
compensated.
Select calibration code C33 (Auto DEV).
Drive the boat in a circle for 1 1/4 turn in calm water. When you
start the circle manoeuvre, press SET.
The un-deviated compass course will be shown in the display as
you turn. Complete the circle up to 1 ¼ turn.
When the manoeuvre is ready, press SET to store the deviation
value.
If the deviation is corrected (Auto DEV) will be displayed.
If the deviation is not corrected, an error message will be
displayed.
To verify the automatic compass deviation, perform an automatic
compass check (Auto CHK), (see 12.4.2).
steer pilot instruments, from version 1.3).
MAG)
rsion 2.0)
bearings will be magnetic.
d bearings will
P
e bearing.
ffects the independent Multi Control
PING (SEA)
ading.
me of heading changes.
, press PLUS and select from:
s SET.
se” the readout on the display, then select
parately for
alibration
43