Filter
Top Products
MULTI CONTROL
12.1.4 C13 DAM
Damping of indicated bo
response time of speed
To change damping, pre
To select damping level
d0 (Min) to d9 (max).
To store the value, pres
Default value is (d0), fo
you may want to ”stabili
(d1) to (d9).
Note! Damping is set se
12.2 C20, calibration of depth
12.2.1 C20 (RET)
To return to normal mod
12.2.2 C21 (Unit m)
Unit for depth. Metre (m
12.2.3 C22 ( - 00
Calibration of the depth
This option is used to s
measured from the water level or the keel.
To measure from the ke
Example: ( - 01.2 ADJ). The distance from the transducer to the
keel is 1.2 m
To measure from the water surface, use the underlining character
( _ ) sign.
Example: ( _ 00.4 ADJ). The distance from the transducer to the
water surface is 0.4 m.
The selected value will be subtracted or added from the measured
depth.
12.2.4 C23 (Unit°C)
Unit for temperature. Celsius (C) or Fahrenheit (F).
12.2.5 C24 (0°C TMP)
Value for compensation of the temperature.
To add, use underlining character ( _ ) ahead of the digit ( _1
TMP).
To subtract, use minus character ( - ) ahead of the digit (-1 TMP).
12.2.6 C25 (Unit hPA)
Future function. Unit for air pressure. Hecto Pascal (hPa) or Inch HG (INH).
PING (SEA)
at speed through the water. Controls the
changes.
ss SET.
press PLUS and select from:
,
s SET.
r use in calm sea. But if the sea is rough,
se” the readout on the display, then select
parately for each instrument.
e, press SET.
), feet (Ft) or fathoms (FA).
.0 ADJ)
transduc
er position.
elect whether the displayed water depth is
el, use the minus ( - ) sign.
41