Filter
Top Products
MULTI CONTROL
12
2 Installation
• The installation inc es
1. Read the installation d
2. Plan where to install
3. Run the cables.
4. Install the transducers and instruments.
5. Take a break and admire your install
6. Learn the functions and calibrate you
Before you begin drilling ... think a
and simple as your boat will allow. P Server
and instruments. Think out leaving al instruments in the future.
• A few ”do nots” you s
− Do not cut the cables too short. Allow extra cable length at the Server so it
can be disconnected for inspection without having to disconnect all
attached cables.
− Do not place sealant behind the display. The instrument gasket eliminates
the need for sealant.
− Do not run cables in the bilge, where water can appear.
− Do not run cables close to fluorescent light sources, engine or radio
transmitting equipment to avoid electrical disturbances.
− Do not rush, take your time. A neat installation is easy to do.
• The following material is needed:
Wire cutters and strippers.
Small and large Philips and small flat head screw driver.
Hole saw for the instrument clearance hole 63 mm (2½").
5 mm (
1
/
4
") drill for the mounting holes.
Plastic cable ties
If you are doubtful about the installation, obtain the services of an experienced
technician.
lud 6 major steps:
an operation manual.
the transducers and instruments.
ation.
r system.
bout ho you can make the installation as neat w
lan where to position the transducers,
ab space for addition
hould consider: