Filter
Top Products
56
ENGLISH
BASIC
CONNECTIONS
BASIC OPERATION
ADVANCED
CONNECTIONS
SETUP
ADVANCED
OPERATION
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTION
ADVANCED
OPERATION
CHANNEL DIRECT CALL
You can select the desired channel by directly tapping
the numeric keypads on the remote controller.
1
.
2
.
3
.
4
.
1.
To select tuner, press the TUNE button twice
within two seconds on the remote controller.
2.
Press the BAND button to select XM band.
3.
Press the F.DIRECT button.
“XM - - -” will appear on the display.
4.
Input the three digit number for your desired
channel with the numeric keypad on the remote
controller.
5.
The desired channel will automatically be
tuned.
Note:
If there is no input on the keypad for 5 sec., the input is
cancelled to return to the original display.
Notes:
•
“LOADING” is displayed while receiving the
channel or information.
•
“CH UNAUTH” is displayed while updating
encryption code.
•
When the selected channel is not available, “CH
UNAVL” is dispIayed.
•
“OFF AIR” is displayed while air is suspended (e.g.
midnight).
PRESET MEMORY
You can store the desired channel in the Preset
Memory.
In addition to AM and FM, it is possible to preset 50
XM Satellite Radio channels.
2. 4.3.
2
.
3
.
(Using the unit)
1.
Tune into the desired channel.
2.
Press the MEMORY button on the front panel.
”- -” (preset number) starts blinking on the
dispIay.
--XM040
3.
Select the preset number by pressing the 1
or 2 cursor buttons, While this is still blinking
(approx. 5 seconds)
01XM040
4.
Press the MEMORY button again to enter.
The display stops blinking.
The channel is now stored in the specified
preset memory location.
(Using the remote controller)
1.
Tune into the desired channel.
2.
Press the MEMO button on the remote
controller. “- -” (preset number) starts blinking
on the display.
3.
Enter the desired preset number by pressing
the numeric buttons.
Note:
When entering a single digit number (2 for example),
either input “02” or just input “2” and wait for a few
seconds.
CHECKING THE XM PRESET CHANNEL
The preset channel can be checked on the on screen
display.
2
.
3
.
4
.
1
.
(Using the remote controller)
1.
To select tuner, press the TUNE button twice
within two seconds on the remote controller.
2.
Press the BAND button to select XM band.
3.
Press the INFO button. to view a list of tuner
preset channeI on the on screen display.
4.
If there are 10 or more preset channel, press
the INFO button again.
XM PRESET LIST
NO. 1 XM010 XXXXXXXXXX
NO. 2 XM011 XXXXXXXXXX
NO. 3 XM015 XXXXXXXXXX
NO. 4 XM022 XXXXXXXXXX
NO. 5 XM125 XXXXXXXXXX
NO. 6 XM001 Preview
NO. 7 XM001 Preview
NO. 8 XM001 Preview
NO. 9 XM001 Preview
NO.10 XM001 Preview
Note:
The preset channel indication disappears in about 5
sec.