Filter
Top Products
ENGLISH
32
BASIC
CONNECTIONS
BASIC OPERATION
ADVANCED
CONNECTIONS
SETUP
ADVANCED
OPERATION
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTION
SETUP
ERROR MESSAGES
Displayed Error Cause How to Remedy
Mic Setup Error!!
Audyssey MultEQ Setup
StartManual Setup
Main Zone Surround Back
Return
Mic Setup Error
Check Microphone
: : Enter : Exit : Exit
: 2ch
• The microphone is not properly connected. • Connect the included microphone.
• Check the microphone connection.
Noise Error!!
Audyssey MultEQ Setup
Speaker Check :
* *
Noise Error!!
: : Enter : Exit : Exit
• There is too much noise in the listening room to measure properly.
• Volume from the speakers is low.
• During measurement, turn off devices that make noise such as air
conditioners.
• Measure at a time when the surrounding area is quiet.
Analyze Error!!
Audyssey MultEQ Setup
Result
Return
Speaker Check :
* *
Analyze Error!!
: Up / Down : Enter : Return Exit : Exit
* Under Analyze Error, select “Result” with the 3/4 cursor buttons
and press the ENTER button. A detail screen like the following
appears on the display.
Speakers Config
Check Speaker Results
Front Left
Center
Front Right
Surround Right
Surround Back Right
Surround Back Left
Surround Left
Subwoofer
Return
: : Enter : Return
Exit : Exit
: Yes Rev
: No
: Yes Rev
: No Err
: Yes
Err
: Yes
Err
: No
Err Rev
: Yes
• The speakers required for suitable playback were not detected.
• Speaker polarity is connected backwards.
In the examples at left, the following trouble is detected.
• The polarity of the left and right channels of the front speakers is
backwards ([Rev] appears on the display.)
• The surround speaker is not connected ([No] is displayed), but the
surround back speaker is connected
(In this kind of situation, [Err] is displayed for all surround and
surround back speakers.)
An error is indicated in addition to the above if the speakers are
connected as follows.
• When using just one surround back speaker, but it is connected to
the surround back R-channel
(To use just one surround back speaker, connect it to the L-
channel.)
• Check the speaker that is indicated as having reversed polarity
([Rev] can appear with some speakers even when properly
connected. In such case, ignore the error indication.)
• Check speaker direction and layout