Kenwood NV-301 Stereo System User Manual


 
Preparation section
5
System connection
Accessories
FM indoor antenna
(1)
AM loop antenna
(1)
Remote control unit
(1)
RC-NV301
RC-NV301E
(For NV-301)
RC-NV701
RC-NV701E
(For NV-701)
Speaker cords
NV-301 (2)
NV-701 (6)
Batteries (R6/AA)
(2)
AC plug adaptor (1)
(Speaker cords are provided in
the speaker package. Be sure to
check that the correct lengths
have been provided.)
Use to adapt the plug on the power
cord to the shape of the wall outlet.
(Accessory only for regions where
use is necessary.)
Unpacking
Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost.
Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer
immediately. If your unit was shipped to you directly, notify the shipping company without delay. Only the consignee (the
person or company receiving the unit) can file a claim against the carrier for shipping damage.
We recommend that you retain the original carton and packing materials for use should you transport or ship the unit in the future.
Keep this manual handy for future reference.
When unpacking the main unit
Plastic protective adhesives have been applied to the front panel of the main unit to prevent minor scratches to the front panel during shipping. Please
remove these adhesives before using this unit.
Connection of the system accessories
CAUTION
Note on Connection
Connect the components as shown in the diagrams. Do not plug the power cord into a power outlet until connections
are complete. The rear panel configuration varies depending on the models (countries or area).
FM indoor antenna AM loop antenna
The accessory antenna is for temporary indoor use
only. For stable signal reception we recommend
using an outdoor antenna. Remove the indoor
antenna if you connect one outdoors.
The supplied antenna is for indoor use. Place it
as far as possible from the main unit, TV sets,
speaker cords, and the power cord, and set it in
the direction that provides the best reception.
1Connect to the antenna terminal.
2Locate a position providing good reception.
3Fix the antenna in place.
FM
75
GND
AM
FM
75
GND
AM
Assemble
12
3