Kenwood NV-301 Stereo System User Manual


 
22
Preparation section
÷ The test tone is output from all of the speakers in the
system in the following order:
÷ While listening to the test tone, use the MULTI CONTROL
keys to adjust the volume levels of each channel when
the channel name is displayed. The test tone continues
to be output from the selected channel while adjustments
are being made. If no adjustments are made for 2
seconds, the test tone resumes the cycle of speaker
channels.
÷ Adjust all of the speakers so that they sound the same
from the listening position.
÷ Because the subwoofer outputs extremely low
frequencies, the volume may sound lower with respect
to the other speakers.
3
L (left front)
3
C (center)
3
R (right front)
SW (subwoofer) 2 LS (left surround)2 RS (right surround)2
The test tone can be turned on and off by press-
ing the MULTI CONTROL keys repeatedly.
“Test ON”
“Test OFF”
4
Turn on the test tone.
5
Set the speaker levels.
6
Complete and save the settings.
To increase
the level
Once you are through adjusting the levels of the
speakers, press the SET key to end the test tone and
conclude adjustments.
Press the ENTER key to save the settings.
+“Press ”ENTER” to save” is scrolled in the display
MULTI CONTROL
ENTER
SET
MULTI CONTROL
To decrease
the level
Press "ENTER
Setting up for surround sound
SET