Kenwood NV-301 Stereo System User Manual


 
38
Application section
Special playback options for CD
1 Select “CD Program Play”.
2 Press the MENU key.
÷ Press the MULTI CONTROL keys during program
playback to go to the previous or next programmed
track.
÷ When the left MULTI CONTROL key is pressed once
during playback, the track being played will be played
from the beginning.
4
Start programmed playback.
÷ If the MENU key is pressed during playback, normal
playback in the order of tracks resumes from the
current track.
÷ The program mode can also be canceled by pressing
the OPEN/CLOSE (0) key.
Goes off
To quit the program mode
Press the TIME DISP. key on the remote control unit
to switch the time display.
(Playback starts from the first programmed
track (program step number 1))
PGM
ENTER
MENU
DEMO
SET
MENU
DEMO
Check the programmed tracks (and replace,
add, or delete tracks as required).
To check:
÷ The blinking item can be replaced.
To replace a track in the program:
÷ The added track number is added to the end of the
existing program.
÷ The programmed tracks are displayed in sequence.
1 Select the programmed disc
or track to be replaced and
press the SET key.
2 Select a disc or track to replace
the disc or track selected above
(step 3-1 and 2).
1 Select the display as shown
on the left, and press the SET
key.
2 Perform the same operation
as in step 3-1 and 2 on the
previous page.
To add a track to the program:
To delete a track from the program:
1 Select the programmed disc
of the step to be cleared and
press the SET key.
2 Select “Clear” and press the
SET key.
Display when 12 tracks have been programmed
MULTI CONTROL
MULTI CONTROL
SET
MULTI CONTROL
SET
MULTI CONTROL
SET
P-01 D1 T01
P-10 D2 T07
P-10 D2 T07
P-13 D? T??
P-12 D1 T03
P-12 Clear
After a program has been made
1
Select “CD Program Play” for pro-
gram editing.
MENU
DEMO
SET
MULTI CONTROL
2
Finish editing and start playback.
ENTER
ENTER