Kenwood NV-301 Stereo System User Manual


 
35
Basic section
4. Select the source to be recorded. (Except for TAPE
input)
The input source component to
be recorded should be displayed.
÷ If a disc has already been loaded when the CD input is selected, it starts to
play automatically. In this case, press the 7 (stop) key to stop it.
÷ When you select VIDEO/6ch IN (NV-701 only) or MD/DVD (NV-301 only) to
record the external input, adjust the input level. Q
Select CD, TUNER, or MD/DVD
(NV-301 only) or VIDEO/6ch IN
(NV-701 only) input for the source.
1 Start recording.
2 Play (or tune) the input source to be recorded.
5. Start recording.
÷ If a disc has already been loaded
when the CD input is selected, it
will starts recording automatically.
÷ Recording stops automatically
when the tape side(s) to be re-
corded have been fully recorded.
÷ Press the stop (7) key of the cas-
sette deck unit to stop recording
(see the next page).
Lights
Let's record
To pause recording (Main unit only)
÷ Pressing the SET () key pauses recording after
leaving a non-recorded space of about 4 seconds.
÷ If the key is pressed again in less than 4 seconds after it
has been pressed, recording resumes from that instant.
Lights
SET
44
CD
TUNER
TAPE
VIDEO/6ch IN
BAND
CD
TUNER
TAPE
MD/DVD
BAND
Press the desired key.
SET
55
SW
REC
RL
NV-301 NV-701
CD01 0:02
•
SW
REC
RL
(SW channel lights
for NV-701 only)
(SW channel
lights for
NV-701 only)