Filter
Top Products
19
KRF-V7771D (En/T)
Setup
Open the “Setup” menu and select “IR” icon.
Setup for controlling AV components
General setup flow
Assigning the connected components to the selected inputs
2
1Select the or icon to select an input.
CD1
MD/ Tape 1
CD 2/Tape 2
TV1
TV2
Video1
Video2
Video3
Video4
2Find out the setup code of the actually connected compo-
nent from the Setup Codes chart and input the code using
icons 1 to ).
3Select the “Check” icon to test the component.
÷ If the proper code has been entered, the component’s power will
turn on. However, the components which have one of the codes
shown on the left and some components from manufacturers
other than KENWOOD cannot be turned on.
÷ Select “Clr (Clear)” icon to cancel.
4Select the “Entr (Enter)” icon to register the code.
÷Icons of the registered components appear on the segment
screen.
Select an input jack name, consult the Setup Codes chart (on the attached sheet) to find out the setup code of the
component connected to the selected input, and enter the 4-digit setup code to assign it to the selected input.
1Open the “Setup” menu and select “IR” icon.
2Assign the connected components to the dis-
played inputs.
3Assign all the connected components.
1
1Select the “Main Menu” icon.
÷If the “Setup” menu screen shown on the left has already been
appeared, step 1 can be skipped.
2Select the “Stp” icon.
3Select the “IR” icon.
Assign all the connected components.
3
Repeat step 2 for each component connected.
Assign the connected components to the displayed inputs.
The inputs are switched every time
the
or icon is selected.
When registering setup codes for KENWOOD audio compo-
nents which are connected to this unit by system control
cords, use the following codes to insure proper system control
operation:
Cassette deck : 7990
Single CD player : 8990
Carrousel CD player: 8991
Multiple CD player (OUTPUT A to CD 1 jacks) : 8992
*1
Multiple CD player (OUTPUT B to CD2/TAPE2 MONITOR jacks)
: 8993*2
MD recorder : 9990
The TV icons that appear on the segment screen after the
setup allow you to use the remote control to control your TV
without connecting it to the receiver as an input.
Lstn Mode
Snd Fnc Stp
Tuner
CD1
Video2
Video3 Video4
Video1
TV1
Phono
TV2
CD2
MD/
Tape1
CD2/
Tape2
Input
Digital
Input
Analog
AV AUX
Macro
Remote
Mode
Main
Menu
SndLsn
Fnc
Setup
IR
Download
Surround Input
Back Li
g
ht
Macro
3
1
2
Setu
p
IR
MD/Tape1
MD
#9990
Entr
Clr
Check
1
2
3
4
5
6
7
8
9
0
Input
selector
Component
1
2
3
4
To delete a setup code
¡
*1This code is only for OUTPUT A operations and for a multiple CD
player which does not have separate outputs such as OUTPUT
A and B.
*2 This code is only for OUTPUT B operations. For a multiple CD
player which does not have separate outputs such as OUTPUT
A and B, use codes on the Setup Code chart.