Filter
Top Products
System connection
9
Knowledge section
Preparation section
Application section
Basic section
Contents
Malfunction of microcomputer
2. Connection of Other Accessories
(Commercially Available Parts)
CAUTION
Conection of Subwoofer (optional)
Extremely low frequency sound is played back powerfully.
Connection of external source component
Digital signal connection
The OPTICAL digital input jack on the rear panel can be used to connect a digital component.
audio input
Subwoofer
(
6-16Ω
)
SERIAL NO.
+
-
+
-
DIGITAL IN
OPTICAL
AUX
(TAPE/MD)
R
L
AUX
(TAPE/MD)
INOUT
¶
1
0
2
7
3
¡
8
audio output
DIGITAL IN
OPTICAL
AUX
(TAPE/MD)
DIGITAL IN
OPTICAL
Optical digital audio output
Optical fiber cable
Digital component
1.In case an associated system component is connected, also read the instruction manual of the component.
2.Insert the optical-fiber cable straight into the connector until it clicks.
3.Be sure to attach the protection cap when the connector is not used.
4.Never bend or bundle the optical-fiber cable.
Notes
Notes
Notes
* Be sure to retain the cap removed above.
Cassette deck etc.
When connections are to be made, make sure that
the power plug is not plugged into a wall AC outlet.
Connect the equipment as shown in the figures.
If operation is not possible or errone-
ous display appears even though all
connections have been made prop-
erly, reset the microcomputer refer-
ring to “In case of difficulty”.
l
Analog signal connection
The AUX (TAPE/MD) input jacks on the rear panel can be used to connect a cassette deck, etc.