Filter
Top Products
75
Timer operation
Knowledge section
Preparation section
Application section
Basic section
Contents
To cancel execution of a timer program (Remote control unit only)
To set the same timer program again (Remote control unit only)
Press the TIMER key repeatedly until “PROG.1” or
“PROG.2” appears.
÷ Also prepare the disc and adjust the listening volume.
÷ The reservation contents are held in memory.
Goes off
Lights
Press the TIMER key repeatedly until “PROG.1” or
“PROG.2” disappears.
÷ Each press increases the set time by 10 minutes. The sleep
timer can be set up to about 90 minutes.
To cancel
\
\
The system has been set so that the LCD bright-
ness drops automatically during the sleep timer
operation. (Auto dimmer)
Turn the power OFF or press the SLEEP key until
the sleep time is cancelled.
Press the SLEEP key during CD or MD playback or
during radio reception.
The sleep timer is used to set the period after which the power will switch OFF automatically.
AU TO
FM P08
BAYERN 3
TONE
STEREO
A.P.S.
12:30PM
RDS
TIMER
TIMER
AU TO
FM P08
BAYERN 3
A.P.S.
12:30PM
RDS
TONE
PROG 1
S
LEEP
T
IMER
5min
TRACK
TONE
12:30PM
SLEEP
S
LEEP
T
IMER
10min
TRACK
TONE
12:30PM
10 =20=30 ....70 = 80= 90 = Cancel
÷ The unit is turned OFF automatically after the set time has
elapsed.
÷ Blinking starts when re-
maining time is 5 minutes
or less.
Note
Note
Note
After the timer has been set and power is off (timer standby), if there is a power failure or the power cord is unplugged from
and plugged again into the power outlet, the /timer indicator blinks in amber. In this case, set the clock again.
Be sure to adjust the clock before setting the timer.
÷ Pressing the SLEEP key once allows you to check the
remaining time. When checking the remaining time, it can
be fine adjusted (in 1-minute steps) using the VOLUME
keys on the remote control unit.
Sleep timer (SLEEP)
(Remote control unit only)