Filter
Top Products
System connection
8
Preparation section
Basic section
Apprication section
Knowledge section
Contents
Connection of speakers
÷ Never short-circuit the + and – speaker cords.
The protection circuit will operate and no sound will be put out.
÷ The + and – polarity are inverted, the sound will be unnatural with unclear localization of musical instruments.
÷ With the speakers of this system, there is no distinction between the left and right speakers.
−
+
1
2
4
3
SERIAL NO.
+
-
+
-
DIGITAL IN
OPTICAL
AUX
(TAPE/MD)
FM
75Ω
GND
AM
(
6-16Ω
)
+
-
+
-
1
2
3
4
−
+
−
+
twist
Speaker rear panel
To wall AC outlet
Main unit
Speaker (Right)
Speaker (Left)
Speaker cord (accessories)
Speaker cord (accessories)
1. Be sure to insert all connection cords se-
curely. If their connections are imperfect,
the sound may not be produced or noise
may interfere.
2. Before plugging or unplugging a connection
cord, be sure to unplug the power cord from
the wall AC outlet.
If connection cords are plugged or unplugged
with the power cord left plugged in, mal-
function or damage may result.
Notes
Notes
Notes
twist
Attaching the speaker nets
Use the following procedure when you want to attach the speaker net to each speaker.
÷ The speaker net has the distinction
between the top and bottom. Check
its back side to attach it in the correct
direction.
Back of the speaker net
Top
Bottom
Align the projections on the back of the speaker net
with the holes on the top edge of the speaker, and
push in gently to attach the speaker net to the speaker.