Filter
Top Products
74
Timer operation
Preparation section
Basic section
Application section
Knowledge section
Contents
÷ The timer operation will not occur if the program is not set to
ON.
Set the program.
Now the program timer reservation is complete.
Use the same procedure as above when you want to
reserve a program timer operation in PROG.2.
6
1 Select “ON” or “OFF” by rotating the volume/
multi-control knob, then press the set key.
Blinks
1When ON is set
Ensure that the power is OFF.
1 Select the preset station No.
2 Press the set key.
ANALOG
MONO
Select the preset sta-
tion No.
3 Select the broadcast station
(only when TUNER is selected).
Press the set key.
Press the set key.
4 Select the recording unit.
(only when TUNER or AUX is selected)
÷ With timer recording of radio broadcasting, the audio is muted automatically at the moment the power is switched ON by
the timer. (
÷ The reservation contents cannot be cleared. The contents are cleared only when they are changed.
÷ If the
/timer indicator blinks in amber when the power is switched OFF (Standby), the timer will not be executed.
In this case, set the clock again. %
÷ After the timer has been set and power is off (timer standby), if there is a power failure or the power cord is unplugged
from and plugged again into the power outlet, the standby/timer indicator blinks in amber. In this case, set the clock again.
1 Select the source to be played.
2 Press the set key.
TUNER
CD
MD
AUX (Analog)
DIGITAL AUX (Digital)
2 Select the input source.
Notes
Notes
Notes
3 Select the broadcast station (only when TUNER is selected).
AU TO
PROG.1
‰
ON
TONE
PROG 1
volume/
multi-control
\
\
set
\
\
\
\
\
\
SOURCE
TUNER
TONE
PROG 1
TUNER P01
90.00MHZ
volume/
multi-control
volume/
multi-control
volume/
multi-control
set
set
set
÷ The set program contents are displayed when the
program is set to “ON”.
\
\
volume/
multi-control
set
÷ The remote control unit can be used only to set the timer
activation ON or OFF. The time setting should be per-
formed on the main unit.
O.T.T.
PROG.1
PROG.2
PROG.1, 2
Goes off (OFF)
Each press switch the modes as follows.
TIMER
timer
Remote control unit operation
2 Press the /timer key to switch the power
OFF (standby).
(The /timer indicator lights in amber.)
Be sure to adjust the clock before setting the timer.