Filter
Top Products
TROUBLESHOOTING
Page 87Monday, 28 March 2005 21:23
Filename [TH-R1R3EU_10Subsidiary.fm]
Masterpage:Left+
87
Timer Recording
● Date and time is not correct.
] Set date and time correctly. (A pg. 19, 82)
● Timer recording is in progress.
] Timer programming can’t be performed while a timer recording
is in progress. Wait until it finishes.
● Date and time is not correct.
] Set date and time correctly. (A pg. 19, 82)
● Date and time is not correct.
] Set date and time correctly. (A pg. 19, 82)
● The channel position does not correspond to that in the
receiving area.
] Set the correct channel position for the receiving broadcast.
(A pg. 18, 78)
● The unit’s channel positions have been set incorrectly.
] Refer to AGuide Programme Number SetB (A pg. 78) and re-
perform the procedure.
● The satellite receiver is not connected properly to this unit.
] Connect the satellite receiver to the unit’s [L-2 INPUT/
DECODER] connector properly. (A pg. 54)
● Power failure occurred.
] Set date and time correctly. (A pg. 82)
● The PC’s data recorded on a DVD-RAM drive cannot be cleared
on this unit.
] Format the disc. (When the disc is soiled, wipe the disc with a
soft dry cloth before formatting.) (A pg. 6, 83)
● All 8 programmes have already been timer programmed.
] Clear unnecessary programmes on the unit, then try timer
programming again.
Audio
● Speaker signal cables are not connected.
] Check the speaker wiring, then reconnect if necessary.
● An incorrect input mode (analogue or digital) is selected.
] Select the correct input mode (analogue or digital).
● TV DIRECT mode is activated.
] The subwoofer turns off automatically once the TV DIRECT
mode is set, thus there is no sound output from the speakers.
Please make use of your TV’s speakers.
● The system cable is not connected.
] Connect the system cable.
● Incoming signal is too weak.
] Connect an outdoor FM antenna or contact your dealer.
● The broadcast station is too far away.
] Select another broadcast station.
● The wrong antenna is being used.
] Check with your dealer to ensure you have the correct antenna.
● Antennas are not connected properly.
] Check the connections.
● Ignition noise from automobiles.
] Move the antenna further away from automobile traffic.
● The built-in processor is not functioning properly.
] Press A on the front panel to turn off the unit.
Remove the power cord and contact your dealer.
Timer programming cannot be made.
Timer programming recording does not start.
S
HOWVIEW Timer Programming cannot be made.
The S
HOWVIEW system does not timer record properly.
Automatic Satellite Programme Recording does not start.
On the front display panel, A-- : --B appears.
The disc space does not increase when recorded titles are
cleared.
APROGRAMME FULLB appears on the TV screen during timer
programming.
No sound from speakers.
Hissing or buzzing sound during FM reception.
Noise during FM/AM reception.
ADSP NGB appears on the front display panel.
TH-R1R3EU_00.book Page 87 Monday, March 28, 2005 9:23 PM