Jabra BT130 Headphones User Manual

Wear it how you like it
The Jabra BT130 is ready to wear on your right ear. If you prefer the left, gently flip and
rotate the earhook 180°. (See fig. 2
For optimal performance, wear the Jabra BT130 and your mobile phone on the same
side of your body or within line of sight. In general, you will get better performance
when there are no obstructions between your headset and your mobile phone.
Fun with colour – changing your cover plate
Remove current plate by pulling from thumbnail slot at top
Push new cover plate into place (See fig. 5)
Answer a call
Tap the answer/end button on your headset to answer a call
End a call
Tap the answer/end button to end an active call
Reject a call (Dependent on your phone supporting this feature)
Press the answer/end button when the phone rings to reject an incoming call.
Depending on your phone settings, the person who called you will either be
forwarded to your voice mail or hear a busy signal
Make a call
When you make a call from your mobile phone, the call will (subject to phone
settings) automatically transfer to your headset
Activate voice dialing (Dependent on your phone supporting this feature)
Tap the answer/end button. For best results, record the voice-dialing tag through
your headset. Please consult your phone’s user manual for more information about
using this feature
Redial last number (Dependent on your phone supporting this feature)
Press the answer/end button
Adjust sound and volume
Press the volume up or down (
) to adjust the volume
(See fig. 1)
How to...
Before you use your Jabra BT130, you need to pair it with your mobile phone.
1. Put the headset in pairing
Make sure that the headset is on.
Press the answer/end button and press the volume up (
) button at the same time,
until a solid blue light comes on.
2. Set your Bluetooth phone to ‘discover’ the Jabra BT130
Follow your phone’s instruction guide. This usually involves going to a ‘setup,’
‘connect’ or ‘Bluetooth’ menu on your phone and selecting the option to ‘discover’
or ‘add’ a Bluetooth device.* (See example from a typical mobile phone in fig. 4)
3. Your phone will find the Jabra BT130
Your phone then asks if you want to pair with it. Accept by pressing ‘Yes’ or ‘OK’ on
the phone and confirm with the passkey or PIN
= 0000 (4 zeros).
Your phone will confirm when pairing is complete. In case of unsuccessful pairing,
repeat steps 1 to 3.
Pair it with your phone
Turn on your headset
Press the answer/end button to turn on your headset
Press and hold the answer/end button to turn off your headset
What the lights mean
What you see What this means about your headset
Flashing blue light Flashing every second: active on a call
Flashing blue light Flashing every three seconds: in standby mode
Flashing red light Running low on battery
Solid blue light Charging
Solid blue light off Fully charged
Solid blue light In pairing mode – (See section 3