Filter
Top Products
FS-2 and FS-2E Studio DTE Disk Recorders User Guide
4 - 1
Part Number: MANL-0927-03
Reference
CHAPTER 4
REFERENCE
This chapter contains reference information for the
FS-2/2E as follows:
Technical Specifications
FS-2/2E LCD Display Modes
Supported RS422 Commands
Shuttle Speed Parameters
Jog Speed Parameters
Custom Commands
Technical Specifications
Input/Outputs
Component - Y, Pr, Pb (3 x BNC in, 3 x BNC out)
if Component SMPTE:
• 100% white at 700mv with 300mv
Sync
• 700mv Chroma levels (100% color
bars)
• Setup default to OFF
• Chroma offset default to OFF
If Component Betacam
• 100% white is at 714mv with
286mv Sync
• 4/3 Chroma boost to 934mv p to p
• Setup default to ON
If Component MII:
• 100% white is at 700mv with
300mv Sync
• Black to White range is restricted
to 647mv (700-setup)
• Setup is ON
Sync (1 x BNC in, 1 x BNC out)
Composite (1 x BNC in, 1 x BNC out)
Monitor Video Out - Composite (1 x BNC)
General Composite Specifications
Differential Phase 2 Degree maximum
Differential Gain 2% maximum
Hue Accuracy 1 Degree
Signal/Noise Ratio Greater than 54 dB
Bandwidth 5.5 MHz
K Factor % @ 2T 1 % maximum
Y/C Delay Less than 25 nS
Subcarrier locking range 100Hz
Subcarrier free-run frequency +/- 30 Hz (NTSC or
PAL Fsc deviation
Genlock Horizontal
adjustment range +
4 uS
Residual Subcarrier Less than 0.5 IRE
SC Phase Less than 2 degrees
S-Video - Y/C (1 x 4-pin DIN in, 1 x 4-pin DIN out)
Levels Adjustments
Video Gain - +/- 20% 2mv resolution
Chroma Gain - +/- 20% 2mv resolution
Setup ON adds 7.5 IRE, or 53mv to
luminance channel
OFF no change to luminance
channel
Serial Digital - SD-SDI (1 x BNC in, 1 x BNC out)
- conforms to the SMPTE 259M standard
The FS-2E outputs embedded audio in
the SDI output stream. This feature is
only available for the FS-2E.
Timecode (1 x BNC in, 1 x BNC out)
Balanced Audio (2 x XLR in, 2 x XLR out) Stereo
Audio Monitor (1 x 1/4” TRS jack)
General Audio Specifications
Balanced Inputs
Input Impedance 600 Ohms +/-10
Ohms
Quantization 16 bits 48Khz
Common mode rejection @1 KHz (dB)100 dB
Analog Input adjustment range -34dB to +4.5dB (in
1.5dB steps, default setting 0dB)
Amplitude with no clipping 3.5Vp-p