Filter
Top Products
FS-2 and FS-2E Studio DTE Disk Recorders User Guide
2 - 27
Part Number: MANL-0927-03
FS-2/2E FUNCTIONS
BETACAM, or MII output levels. Refer
to Chapter 4 for more information.
The selected mode becomes highlighted after you
select Exit.
Network Setup
With NETWORK SETUP, you can connect the
FS-2/2E to a network. When this is done, you can
do FTP file transfers to or from the FS-2/2E or
control the FS-2/2E using Telnet. The FS-2E, or
FS-2, with the 2.0 software upgrade also allows you
to control using your internet browser. The
NETWORK SETTINGS MENU contains the
following:
IP SETTINGS
USER/PASSWORD
VIEW IP INFO
SERVICES
FOCUS Enhancements is in no way liable for
device security (Telnet and FTP). Contact your
system administrator regarding the best security
practices.
IP SETTINGS
With the IP settings menu item, you can select
either DHCP (the network provides the IP address)
or a CUSTOM IP.
If you select DHCP and then EXIT, the FS-2/2E
attempts to log onto the network.
If you select CUSTOM IP, a submenu opens to ask
you to enter an IP number, Sub Net Mask, and
Gateway.
If you do not have these values, contact your
system administrator. The default values for the IP
address is 000.000.000.000, Sub Net Mask
255.255.255.000 and Gateway 000.000.000.000.
To modify the custom IP values use the following
steps:
S
TEP 1: Select the item to modify.
S
TEP 2: Press to select the field to change.
S
TEP 3: Use the to increase the value (HINT:
press the SHIFT key on the FS-2/2E
front panel plus to decrease a
value).
Values wrap back to zero once the
maximum value has been entered.
S
TEP 4: To modify the next item or set of
values, press the NEXT key on the
FS-2/2E front panel.
S
TEP 5: Once complete, press the SEL key
when EXIT is highlighted to exit or the
NEXT key to continue to modify items.
Once you exit the menu, the FS-2/2E attempts to
log into the network and one of two things happen:
If the FS-2/2E successfully logs onto a
network, it displays NETWORK
CONNECT SUCCEEDED.
If the FS-2/2E is unable to log onto a
network, it displays “NET CONNECT
FAILED. CHECK NETWORK CABLE”.
Press the VERIFY button on the FS-2/2E to take
you back to the IP Settings menu to verify your
values.
DHCP
CUSTOM IP
EXIT SEL
IP ADDRESS 000.000.000.000
SUBNET MASK 255.255.255.255
GWY 000.000.000.000
EXIT
NEXT SEL