FS-2 and FS-2E Studio DTE Disk Recorders User Guide
2 - 29
Part Number: MANL-0927-03
FS-2/2E FUNCTIONS
An example of the web interface is shown below.
Ref Video
The Reference video menu allows you to select
where the reference video source will come from for
playback and whether the video out will be locked to
the reference video input in playback modes,
Choices are:
REF VIDEO - the reference video port
on FS-2/2E's rear panel,
FREE RUN - reference video is
generated on the FS-2/2E.
NOTE: If the loop-through jack is not connected,
make sure the output is terminated using an
external 75 ohm terminator.
Video Out Adj
The VIDEO OUT ADJ menu options allow you to
make adjustments to FS-2/2E analog output
sources.
HUE - adjustable between -179 and
+180
SATURATION- adjustable between -
255 and +256
BRIGHTNESS- adjustable between -
127 and +128
CONTRAST- adjustable between -127
and +128
BLACK LEVEL - Allows the output
black level to be set to either 0 IRE or
7.5 IRE. 0 IRE is the default setting.
This menu item is only present when
the FS-2/2E is set to NTSC mode.
SC PHASE - Allows the subcarrier
phase to be adjusted between +127
and -128. The default value is set at 0.
Press and hold either or for more
than 3 seconds to change the value by
increments of ten.
H PHASE - Allows the horizontal
phase to be adjusted between +127
and
-128. The default value is set at 0.
Press and hold either or for more
than 3 seconds to change the value by
increments of ten.
NOTE: The HUE, BLACK LEVEL, and SC PHASE
adjustments are not available when the unit is
configured for component out.
Compnt Level
Note: This is available only in NTSC mode. It is not
available in PAL mode.
For both the component inputs and outputs you can
select from three video signal level standards:
SMPTE
BETA
MII
Refer to Chapter 4 for more details.
Utilities Menu
This menu allows you to access various utilities.
Select the Menu Item. Press SEL to
open the sub menu (where
applicable).
Press EXIT to return to the menu
screen.
This menu contains the following selections:
ORGANIZE PINN
ORGANIZE CLIP
ORGANIZE PINN
ORGANIZE OMF
DELETE CLIP
EXIT SEL