Filter
Top Products
FS-2/2E FUNCTIONS
FS-2 and FS-2E Studio DTE Disk Recorders User Guide
2 - 24
Part Number: MANL-0927-03
Press EXIT to return to the menu
screen.
NOTE: You cannot set UB values after selecting
EXT TC mode in the TC MODE menu.
For DROP and NON-DROP, select the
mode. The highlighted mode is the
current mode after exit.
Press EXIT to return to the menu
screen.
This selection is not applicable for PAL use. On the
FS-2/2E display, DROP is identified by a semicolon
(;) and NON-DROP by a colon (:).
TC Delay (FS-2E only)
The TC DELAY menu is only available for the
FS-2E, or FS-2 (with the 2.0 upgrade). This menu
allows you to delay the recorded timecode up to 29
frames.
TC DELAY: 00
Use (middle soft key) and (right soft key) to
adjust the delay value. Press EXIT when done.
On Screen Display
This selection allows you to turn on or off the on-
screen display on FS-2/2E's Monitor Output. The
highlighted item is saved after exit.
When you select ABS, the absolute timecode value,
or amount of time recorded to the disk, appears on
the bottom center of the monitor output.
When you select TC, the TC (Counter) timecode
value appears on the bottom center of the monitor
output.
When you select MENU, the FS-2/2E Menu
appears in the top left corner of the monitor output.
Press and to scroll though the
selections.
Press EXIT to return to the menu
screen.
NOTE: By repeatedly pressing the front panel OSD
key, you can cycle between these modes.
FF/RW Hi Res
This screen enables or disables the FS-2/2E
forward and reverse search high resolution mode.
When enabled the following search speeds are
available:
REVERSE: -30X, -25X, -18X, -15X, -
12X, -10X, -8X, -5X, -4X, -3X, -2X,
-1/30, -1/15, -1/10, -1/6, -1/5, -1/3,-1/2
FORWARD: +30X, +25X, +18X, +15X,
+12X, +10X, +8X, +5X, +4X, +3X,
+2X, +1/30, +1/15, +1/10, +1/6, +1/5,
+1/3, +1/2
The highlighted mode is the current
mode after exit.
Press EXIT to return to the menu
screen.
UB PRESET
F:00:00:00:00
| & |
MOVES CURSOR
EXIT
DROP
NON-DROP
EXIT
ABS
TC
MENU
OFF
EXIT