Filter
Top Products
FS-2 and FS-2E Studio DTE Disk Recorders User Guide
2 - 21
Part Number: MANL-0927-03
FS-2/2E FUNCTIONS
appears:
S
TEP 11: Select YES. You are warned with the
following display:
S
TEP 12: Select YES to begin the OS upgrade.
A message appears indicating the upgrade has
begun.
S
TEP 13: After upgrade is complete, power cycle
the FS-2/2E. The new software should
now be loaded and ready to use.
If no .bin file is found, the screen displays “OS
UPGRADE ERROR”. Check your connections and
make sure you have the correct file name.
You must restart your system once an OS upgrade
is complete.
NOTE: If you need to restore the factory default
Operating System, hold down the Left and Middle
soft keys under the LCD during boot up.
PAL/NTSC
Use this screen to select the record standard as
either PAL or NTSC. The highlighted selection is
the current one after exit. The FS-2/2E uses this
video standard for both playback and record.
NOTE: Do not combine PAL and NTSC clips on a
single drive.
RS422 Remote
This submenu allows you to setup the FS-2/2E for
remote operation using the RS422 control port.
For easy integration with existing control systems,
you can make the FS-2/2E look like either a Sony
BVW-75 Betacam SP deck or a generic recorder.
Using the TC SOURCE submenu, you can also
select the timecode source for FS-2/2E control.
Options are ABS, DV and COUNTER.
You can set the FS-2/2E to two different remote
modes:
BVW-75 – The FS-2/2E appears as
and is identified as a Sony BVW-75
BetaSP deck to the remote control
device.
NOTE: Some BVW-75 control func-
tions are not available on the FS-2/2E.
The FS-2/2E mainly responds to com-
mands such as PLAY, STOP,
REWIND, REC, FF, and so on. Com-
mands such as Insert, Edit, and other
specialty commands are not possible.
Refer to “Supported RS422 Com-
mands” on page 4-3 for more informa-
tion on supported commands.
Generic - The FS-2/2E appears as and
is identified as a generic device to the
remote controller.
UPGRADE
SYSTEM
FIRMWARE
EXIT YES NO
UPGRADE WILL
ERASE CURRENT
OS!!!
CONTINUE?
EXIT YES NO
NTSC
PAL
EXIT
TYPE
TC SOURCE
EXIT