Filter
Top Products
FS-2 and FS-2E Studio DTE Disk Recorders User Guide
1 - 9
Part Number: MANL-0927-03
INTRODUCTION
To set up the FS-2/2E, do the following:
S
TEP 1: Plug in the power cord.
S
TEP 2: Connect a Video input device.
S
TEP 3: Connect an Audio source (if desired).
S
TEP 4: Connect a Monitor if desired.
S
TEP 5: Connect Speakers or Headset (to
monitor the audio) if desired.
S
TEP 6: Connect a Tape Drive if desired.
S
TEP 7: Connect a Time Code Generator if
desired.
S
TEP 8: Connect an External Control Device
(RS422) Device if desired.
S
TEP 9: Connect a Reference Video signal if
desired.
Formatting the Drive
Use this procedure to format the FS-2/2E internal or
connected external disk drives when not yet
formatted.
S
TEP 1: From the Utilities Menu, select
FORMAT DISK as shown below.
When you make this selection, the fol-
lowing screen appears:
S
TEP 2: Select between volumes by pressing
the | and | buttons.
• When you select the volume and
press YES, the following screen
appears:
• When you select YES, a message
indicating that the formatting is
progressing appears.
S
TEP 3: Press EXIT to return to the menu
screen.
WARNING: FORMAT ERASES ALL DATA ON
THE DISK DRIVE!
Setting the Time and Date
Before using the FS-2/2E, use this procedure to set
the time and date.
S
TEP 1: Select the Setup Menu.
S
TEP 2: Select SET DATE & TIME. The
following screen appears.
S
TEP 3: Select SET DATE or SET TIME and
press SEL to open the sub menu as
shown below.
FORMAT DISK
VOLUME 1? :
SIZE 115GB
FREE 540 MIN
EXIT YES NO
FORMAT WILL
ERASE ALL DATA!! :
CONTINUE FORMAT
VOL 1?
EXIT YES NO
SET DATE
SET TIME
EXIT SEL
SYSTEM DATE
02/24/02
MM/DD/YY
| & |
MOVES CURSOR
EXIT
SYSTEM TIME
16:21:13
Hh:Mm:Ss
| & |
MOVES CURSOR
EXIT