Filter
Top Products
2-17
DVS 304 • Installation and Operation
Clear (CLR memory preset
From this submenu, up to three saved presets for the currently selected input can
be cleared from memory.
1. Using either the Adjust horizontal ([) or Adjust vertical ({) knob, select (< >)
either N/A, 1, 2, or 3 to select a preset. The default is <N/A>.
2. To clear the preset, press the Next button.
N
Clearing a preset by pressing the Next button will also cause a return to the
Memory Preset menu.
To exit the Clear memory preset function without clearing a preset, press Menu.
Recalling a preset
Recalling a saved preset requires that the desired input be currently selected and
that the input button be pressed successively to activate each saved preset (up to
three). Each saved preset will display the message “Input #X Memory Y”, where
“X” refers to the input (1 to 4) and “Y” refers to the preset (1 to 3).
In the absence of any saved presets, the “Input #X Memory Y” message will not be
displayed for those presets.
N
The presets are specific to a selected output rate. If the output rate is
subsequently changed, the previously saved preset will have no effect on the
video output. However, if the original output rate is later restored for a saved
preset, the preset will re-apply to that output rate.
Input preset
Input preset saves current values for parameters such as input type, color, tint,
contrast, brightness, detail, aspect ratio, horizontal start, vertical start, horizontal
active, vertical active, phase, total pixels, horizontal position, vertical position,
horizontal size, vertical size, zoom, and OSD text.
IP conguration
The IP Configuration menu displays the IP address of the unit, the Subnet mask,
and Gateway IP address.
View IP address
of the unit.
View the subnet mask
of the unit.
View gateway IP address
of the unit.
MEMORY
PRESETS
MENU
NEXT
IP
CONFIG
NEXT
NEXT
NEXT
I 196.168
P 254.254
S 255.255
M 000.000
G 000.000
M 000.000
Figure 2-16— IP Configuration menu
To change an IP address, do the following:
1. Press and hold the Input 4 and Next buttons simultaneously for 2 seconds.
This introduces the Setup mode.
2. Change the flashing octet selection by using the Adjust vertical ({) knob.
Change the selection numbers by using Adjust horizontal ([) knob.
3. Press the Menu button to return to the IP address setup and the Next button
to select another address setup.
4. Press the Menu button to save and exit.
The IP configuration menu “times out” if there is no activity for over 10 seconds.