Filter
Top Products
2-3
DVS 304 • Installation and Operation
Rack mounting the DVS 304
1. If feet were installed on the bottom of the DVS 304, remove them.
2. Place the DVS 304 on one half of the 1U (one unit high, one unit wide) rack
shelf (part #60-190-01). Align the front of the DVS 304 with the front of the
shelf, and align the threaded holes on the bottom of the DVS 304 with the
holes in the rack shelf.
3. Attach the DVS 304 to the rack shelf with the two provided 4-40 x 1/16"
machine screws. Insert the screws from the underside of the shelf, and
securely fasten them into diagonally-opposite corners (figure 2-1).
(2) 4-40 x 3/16" Screws
Use 2 mounting holes on
opposite corners.
False front panel
uses 2 front holes.
Figure 2-1 — Rack mounting a half rack device
4. Attach the false front panel (provided with the universal rack shelf) to the
unoccupied side of the rack (as shown above), or install a second half-rack-
width device in that side by repeating steps 1 – 3.
5. Attach the rack shelf to the rack using four 10-32 x 3/4" bolts (provided).
Insert the bolts through #10 beveled washers, then through the holes in the
rack ears and rack (figure 2-1).