Filter
Top Products
92
Example #2:
Weekday Start-6:00 p.m. Weekday Stop-6:00 a.m.
Weekend Start-4:00 p.m. Weekend Stop-8:00 a.m.
• Monday—ursday evenings at 6:00 p.m., the MATE will issue a USE command to the FX
allowing the AC input source to be used.
• Monday—Friday at 6:00 a.m., a <DROP> will be issued. On Friday evening at 6:00 p.m., a
USE will be issued.
• e following morning is a weekend (Saturday) so a DROP command will be issued at 8:00
a.m. During Saturday aernoon at 4:00 p.m., the FX will USE again until Sunday morning at
8:00 a.m. On Sunday evening at 4:00 p.m., a USE time period will start, ending on Monday
morning at 6:00 a.m.
To enter grid use mode:
Press until 141 and then press enter.
MAIN
9:57:32 A
SUM STATUS SETUP ADV
ADV/PASSWORD------------------
enter the password
132
ENTER INC DEC EXIT
ADV/SETTINGS/WARNING
changes made could
adversely affect
system performance
ADV/MATE-----------------------------
choose category:
HBX GRIDUSE AGS PG2
ADV/MATE/GRIDUSE----------------
weekday 12:00A
griduse start time
DOWN UP CHANGE
ADV/MATE/GRIDUSE----------------
griduse enable: Off
DOWN ADV OFF ON
ADV/MATE/GRIDUSE---------------
weekend 12:00A
gridusestart
DOWN ADV OFF ON
ADV/MATE/GRIDUSE----------------
weekend 12:00A
griduse stop
DOWN UP CHANGE
ADV----------------------------------
choose device:
FX CC DC MATE
ADV/MATE/GRIDUSE--------------
weekday 12:00A
griduse stop time
DOWN UP CHANGE
NOTE:
• If the battery voltage falls below the FX’s Low Battery Cut-O voltage, the FX will
automatically connect to the AC input source regardless of the GRID-USE time of day setting.
• Because GRID-USE Mode uses the DROP and USE commands, it cannot be enabled at the
same time as HBX Mode. Enabling GRID-USE will automatically disable HBX Mode.
• GRID-USE Mode only allows one Drop and Use per day. GRID-USE can be aected by the
MATE not automatically adjusting its clock for Daylight Savings Time.
• A START time that equals a STOP time disables a change during that period (weekdays
or weekends). If disabled, the current USE or DROP command will continue through the
disabled period. If both the weekday and weekend periods have START and STOP times that
are the same, respectively, the GRID-USE Mode will be completely disabled.