Filter
Top Products
53
• When an OutBack HUB is employed, the GEN START CONTROL only aects the FX
programmed as the AGS PORT in the AGS setup. is is the HUB Port connected to the
FX with the generator start relay.
<OFF> manually overrides AGS mode. Pressing <OFF> brings up MAN-OFF indicating the
user manually shut o the generator.
<AUTO> allows the MATE to automatically start and stop the generator according to the
settings programmed in the AGS menu. Pressing <AUTO> brings up either AUTO-OFF or
AUTO-ON depending on the FX programming.
<ON> manually overrides AGS mode. Pressing it brings up MAN-ON indicating the user
manually turned the generator ON)
<OK> Returns to the point in the menu system where you entered the GEN START
CONTROL screen.
AC INPUT CONTROL
currently: USE
DROP USE OK
PRESS TWICE:
• e GEN START CONTROL screen allows
changes to the Advanced Generator Start
(AGS) mode.
• e AGS settings only take eect when
Advanced Generator Start is enabled (See the
AGS Mode section for more information).
NOTE: is does not control the GenAlert
function.
NOTE: To reset an AGS error, press <OFF> and then press <AUTO>.
PRESS THREE TIMES:
CHARGER CONTROL
currently: OFF
OFF AUTO ON OK
• e CHARGER CONTROL screen appears.
• is allows the operation of the FX battery
charger to be preset for an available AC source.
• When an OutBack HUB is employed, the
CHARGER CONTROL only aects the Master
FX connected to PORT 1. e Master FX then
gives the same command to all slave FXs.