Filter
Top Products
Displaying Stream Content
72
MAX-CSE/MAX-CSD10 Operation/Reference Guide
For the purposes of these procedures, we are not required to enter a Target Audio Port value
because the A/V content is not begin streamed separately.
6. Click the Apply button to save the encoding profiles to the MAX-CSE.
7. Complete the media configuration procedures outlined within the previous Configuring the MAX-
CSE audio/video inputs section on page 67.
Establishing the final connection between the CSE and computer
1.
Start playing the media at its source (DVD, VCR, camera, etc.).
2. While in the UI pages (log back in if not already connected), navigate to the Administration page by
clicking on the Admin link from the left Navigation frame.
3. Locate the Mode section of this page and click the Play button to begin streaming the incoming
media content to the targeted Modero panel. For these procedures, the Program information is
optional and not "picked-up" by the application.
4. Double-click on the desktop icon to launch the pre-installed VLC player (A in FIG. 48).
5. Click File > Open Network Stream to launch the Open dialog where you can configure the
properties of the incoming media stream (B in FIG. 48).
6. Click on the Network tab and select the UDP/RTP radio box from the left side of this dialog.
7. Use the Port field to enter the value used with in the Target Port field in the MAX’s Encoder Profiles
page.
8. Click the OK button to accept the parameters and maximize the window to begin displaying the
incoming stream. There might be a delay of a few seconds while the unit attempts to synchronize
itself with the incoming stream.
If there is no video being displayed within the player, confirm that the information which was
previously entered into the Stream section of the MAX’s Encoder Profiles page matches the
parameters for both the target computer and target port.
If this still doesn’t produce a displayed signal, cycle the Play/Stop buttons and verify that both
the encoding Status says Streaming (verifying that the process of encoding is underway) and
If using RTP, both the Target Port and Target Audio Port must be different.
FIG. 48 VLC Player Adjustments (using a sample UDP stream to display both A/V in one window)
A
B