Filter
Top Products
MAX-CSD10 Video Decoder
6
MAX-CSE/MAX-CSD10 Operation/Reference Guide
The following table outlines the specifications for the MAX-CSD10 Video Decoder.
MAX-CSD10 (FG2178-72) Specifications
Dimensions (HWD): 1.58" x 5.54" x 6.95" (4.01 cm x 14.07 cm x 17.65 cm)
Power Requirements: • 500mA @ 12VDC (6W)
• Power Over Ethernet (
POE) is available.
• Optional 12VDC power input overrides
POE when used.
• Power requirements are usage dependant.
• This product is intended to be supplied by a Listed external power supply
rated from 10 to 18 VDC, minimum 500 mA or equivalent.
Weight: 2.02 lbs (0.92 kg)
Enclosure: Metal with black matte finish
Certifications: FCC Part 15 Class B, CE, and UL listed
Video Outputs: Composite Video (via BNC)
S-Video (via standard female S-Video connector)
Audio Outputs: Analog Stereo (RCA connectors - Red/White)
Supported Resolutions: • NTSC (480i)
• PAL (576i)
Supported Video Codecs: • MPEG2 (2 Mbps - 6 Mbps)
• MPEG4 (500Kbps - 3 Mbps)
Supported Audio Codecs: • MPEG Audio Level 2 (MP2)
• MPEG Audio Level 3 (MP3)
• AAC
Front Panel Components:
• ID Pushbutton: Used to both set the NetLinx ID (Device only) assignment and reset the unit
back to its factory defaults.
• Status LED: Green LED blinks to indicate both the system and communication status with
the target Master.
• LCD Display: Provides system information such as the currently used IP Address.
• IR Receiver: • Receives 38KHz AMX IR codes.
Rear Panel Connectors:
• S-VIDEO OUT: Mini-Din4 port for composite S-Video output.
• ETHERNET 10/100: Single RJ-45 port provides 10/100 Mbps network communication and
POE.
LEDs show communication activity, connections, speeds, and mode informa-
tion.
• AUDIO R/L: Two RCA connectors (Red and White) support line-level stereo output for ana-
log stereo signals.
• 12VDC PWR: Single 2-pin 3.5mm mini-Phoenix (male) captive-wire connector from an
optional 12 VDC power supply (overrides
POE).
• COMPOSITE OUT: Composite Video Output (NTSC or PAL) via a female BNC connector.
• IR/Serial: Single 2-pin 3.5mm mini-Phoenix (male) captive-wire connector is used for IR/
Serial control output by generating IR with the use of an IR emitter (while in IR
mode).
This port can support high-frequency carriers of up to 1.142 MHz and can also
generate IR with no carrier frequency.