Filter
Top Products
These commands control the appearance of your source. These settings are unavailable when the
projector is in Standby mode orwhen the source is disconnected. See Value-based command
methods on page 86 for setting absolute and adjustment commands.
Command Command target range Response
set displaymode [target] =SMARTpresentation
=brightroom
=darkroom
=sRGB
=User
displaymode=[target]
set brightness [value] =0 to =100 brightness=[value]
set contrast [value] =0 to =100 contrast=[value]
set whitepeaking [value] =0 to =10 whitepeaking=[value]
set degamma [value] =0 to =3 degamma=[value]
set red [value] =0 to =100 red=[value]
set green [value] =0 to =100 green=[value]
set blue [value] =0 to =100 blue=[value]
set cyan [value] =0 to =100 cyan=[value]
set magenta [value] =0 to =100 magenta=[value]
set yellow [value] =0 to =100 yellow=[value]
set videofreeze [target] =on
=off
videofreeze=[target]
set cc [target] =cc1
=cc2
=off
cc=[target]
N OTE
Typically, cc1 displays English (U.S.) subtitles, while cc2 displays other regional languages, such
as French or Spanish, depending on television channel or media setup.
Additional VGA source controls
Your VGA source supports all the general source controls described in General source controls on
the previous page, as well as the commands listed in this section. These settings are unavailable
when the projector is in Standby mode orwhen the VGA sources are disconnected.
N OTE
Some of these commands are invalid with HDMI input and Composite video sources, and will
return the response “invalidcmd=[command]”.
A PPEND IX B
Remotelymanagingyour systemthroughan RS-232 serialinterface
90