Filter
Top Products
15-EN
To display the DVD mode screen
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1. Push the foot brake to bring your vehicle to a complete
stop at a safe location. Engage the parking brake.
2. Keep pushing the foot brake and release the parking
brake once then engage it again.
3. While the parking brake is being engaged the second
time, release the foot brake.
•For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the DVD mode operation has been
released. Engaging the parking brake can reactivate the DVD mode,
as long as the car's ignition has not been turned off. It is not
necessary to repeat the above procedure (1 through 3), of “To display
the DVD mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the DVD mode screen.”
• If you try to activate the auxiliary device while driving, the display
will show the warning-PICTURE OFF FOR YOUR SAFETY.
Caution
• Not all functions will operate for every DVD. See
the individual DVD’s instructions for details on
the features supported.
• Fingerprints on a disc may adversely affect
playback. If a problem occurs, remove the disc
and check for fingerprints on the playback side.
Clean the disc if necessary.
• If you switch the power or Ignition Key OFF or
change sources during playback, playback will
continue where you left off when you resume
playback.
• If you try to perform an invalid operation (based
on the type of disc being played), the following
mark is displayed on the monitor screen:
•Play Position Memory Function
Even if you turn power off or switch the Ignition
Key to OFF during playback or change the
source, playback will continue from the point
where playback stopped when the power is
turned ON again.
Continued
1
Press SOURCE/POWER to display the main menu
screen.
2
Turn the Rotary encoder and select DVD PLAYER
from the menu. Then, press the Rotary encoder
to execute the selection.
The display shows the DVD player mode screen.
Insert a disc with the label side facing up. The unit starts
to play the disc. The display shows the Function Guide.
When an optional Alpine DVD player is connected:
Insert a disc into the DVD/video CD/CD player, the player
starts playing.
To eject the disc
Press c.
•Press 6 (GUIDE) during DVD/Video CD playback to turn on or
off the Function Guide display.
In the ON position:
The Function Guide display will always be shown.
In the OFF position:
The Function Guide display will disappear after approx. 5
seconds if no button is pressed.
If you want to display the Function Guide screen again, press
any one of the Function buttons.
• When the Function Guide display is ON, you cannot switch the
display mode by pressing and holding WIDE/DISP for at least 2
seconds.
• The reverse side of a double-sided DVD will not be played
automatically.
Remove the disc, turn it over, and reinsert it.
• DO NOT insert discs containing maps for the navigation system.
Doing so could result in damage.
• When video CDs to which titles are input are inserted, the list of
the titles can be displayed to select a desired disc (Displaying the
title list, pages 24 and 25). A DVD disc cannot be titled. "DVD
VIDEO" is displayed at the title list.
• Refer also to "DVD Setup" (pages 28 to 31).