Filter
Top Products
11-EN
Radio
Listening to the Radio
1
Press SOURCE/POWER.
The main menu screen appears.
2
Turn the Rotary encoder to select "RADIO," then
press the Rotary encoder.
The radio mode is activated and the display changes to
the Radio Mode screen.
3
Press BAND to select the desired radio band.
Each press changes the bands as follows:
FM1 → FM2 → AM → FM1
4
Press 2 (TUNE) to choose the tuning mode.
Each press changes the function modes for the buttons
1 and 3 as follows:
Distance → Local → Manual → Distance
gg
gg
g
ff
ff
f
g g
g g
g
f (f (
f (f (
f (
))
))
)
gg
gg
g
ff
ff
f
• There are two modes you can select for auto tuning, DX and
Local:
- DX (Distance) mode (with DX SEEK indicator ON);
Both strong and weak stations will be tuned in.
- Local mode (with SEEK indicator ON);
Only strong stations will be tuned in.
The initial setting is DX.
5
Press 1 (() or 3 ()) to change the radio
frequency downward or upward respectively.
When the button is pressed and held, the frequency
changes continuously until the button is released.
• When a stereo FM station is tuned in, the STEREO indicator
appears in the display.
Manual Storing of Station Presets
1
Tune in a desired radio station you wish to store in
the preset memory by manual or automatic seek
tuning.
2
Press 7 (PAGE 1/2).
3
Press and hold any one of the Function buttons 1
(P.SET1) through 6 (P.SET6) for at least 2
seconds.
The selected station is stored.
4
Repeat the procedure to store up to 5 other
stations onto the same band.
To use this procedure for other bands, simply select the
band desired and repeat the procedure.
A total of 18 stations can be stored in the preset memory
(6 stations for each band; FM1, FM2, AM).
• If a preset memory has already been set in the same Function
button, it will be cleared and the new station will be memorized.
Automatic Memory of Station Presets
The tuner can automatically seek and store 6 strong stations in the
selected band in order of signal strength.
1
Press BAND in the radio mode to select the
desired radio band.
2
Press 6 (A.MEMO).
The tuner automatically seeks and stores 6 strong stations
into 1 (P.SET1) to 6 (P.SET6) in order of signal strength.
When the automatic storing has been completed, the
tuner goes to the station stored in 1 (P.SET1).
• If no stations are stored, the tuner will return to the original station
you were listening to before the automatic storing procedure
began.
Tuning to Preset Stations
You can tune in the preset stations in memory on each band using the
Function buttons.
1
Press BAND in the radio mode to choose the
desired radio band.
2
Press 1 (P.SET1) through 6 (P.SET6) that has
your desired preset station in memory.
The preset station is received.
Rotary encoder
BAND
SOURCE/POWER
7
6
5
4
3
2
1