Filter
Top Products
97 En
Graphical user interface (GUI) menu
ADVANCED
OPERATION
Manual parametric equalizer configuration of
each speaker
Use this feature to adjust the tonal quality of each speaker.
You can copy the results of the automatic setup for the
base of the manual configuration by using “PEQ Data
Copy”. Set “PEQ Select” to “Manual” in advance.
1 Press
9
k / n / l / h to select “Test Tone” or
the speaker you want to adjust.
Test Tone
Use this feature to select whether to turn on or off the
test tone output while you are adjusting the tonal
quality of each speaker.
2 Press
9
h to access the settings window.
3 Press
9
k / n / l / h to select “PARAM” and
then press
9
ENTER repeatedly to select a
parameter from “Band” (band), “Freq.”
(frequency) or “Q” (Q factor).
y
You can adjust “Gain” (gain) with any parameter.
4 Press
9
n to select “EDIT” and press
9
ENTER to access the edit window.
For more information on the parametric equalizer and
each parameter, see page 153.
The parameter selected in “PARAM” is highlighted.
•Press
9
l / h to adjust the parameter.
•Press
9
k / n to adjust the “Gain”.
•Press
9
ENTER to exit the edit window.
y
• When you select “Band” in step 3, you can use this menu
as a graphic equalizer.
• “Band #5”, “Band #6”, and “Band #7” can adjust the
frequencies of above 500 Hz.
• When you select “Subwoofer” in step 1 and “Band” in step 3,
you can adjust “Band #1”, “Band #2”, “Band #3” and “Band
#4” only. In this case, “Band #1”, “Band #2”, “Band #3” and
“Band #4” adjust the frequencies of below 200 Hz.
5 Repeat steps 3 and 4 until you are satisfied
with the results.
y
If you want to reset all “Parametric EQ” parameter settings
for the selected speaker, select “RESET” and press
9ENTER.
6 Select “EXIT” and press
9
ENTER to exit
from the settings window.
■ Tone Control (Tone control)
Use this feature to adjust the balance of bass and treble
output to your speakers or headphones.
Tone Control is not effective when:
– the PURE DIRECT mode (page 54) is selected.
– MULTI CH is selected as the input source.
Control (Control mode)
y
“Speaker” and “Headphone” adjustments are stored
independently. The adjustments for “Speaker” affects the front
left/right speaker, center speaker and subwoofer channels.
Choice Adjusted speaker
Front L
Front left speaker
Front R
Front right speaker
Center
Center speaker
Surround L
Surround left speaker
Surround R
Surround right speaker
Surround Back L
Surround back left speaker
Surround Back R
Surround back right speaker
Front Presence L
Front presence left speaker
Front Presence R
Front presence right speaker
Subwoofer
Subwoofer
Choice Functions
On
Outputs the test tone.
Off
Does not output the test tone.
PEQ Data Copy
PEQ Select
Front L
Front R
Center
PARAM RESET
EDIT EXIT
Band / Gain
Note
Choice Functions
Speaker
Adjust the bass/treble balance of your speakers.
Headphone
Adjust the bass/treble balance of your
headphones.
PEQ Data Copy
PEQ Select
Front L
Front R
Center
Band #1
Gain 0.0dB
Freq 62.5Hz
Q1.000
Exit:ENTER