Filter
Top Products
55 En
Using audio features
BASIC
OPERATION
You can adjust the output level of each speaker while
listening to a music source. This is also possible when
playing sources input at the MULTI CH INPUT jacks.
This operation will override the level adjustments made in the
automatic setup (page 35) and “Level” (page 94).
1 Press
C
LEVEL and then 9k / n repeatedly
to select the speaker you want to adjust.
y
The available speaker channels differ depending on the
speaker settings.
2 Press 9l / h on the remote control to
adjust the speaker output level.
Control range: –10.0 dB to +10.0 dB
Use this feature to select a source component from which
you want to record.
1 Press and hold
C
REC OUT until “REC
OUT” appears in the front panel display.
2 Rotate
M
PROGRAM to select the source
component.
y
To record the input source currently selected, select “SOURCE”.
When zone 4 is turned on, no signal is output at the DVR OUT,
VCR OUT and MD/CD-R OUT jacks.
Before performing the following operation, set the operation
mode selector on the remote control to
F
AMP.
Adjusting the speaker level
Note
Display Adjusted speaker
FRONT L
Front left speaker
FRONT R
Front right speaker
CENTER
Center speaker
SUR.L
Surround left speaker
SUR.R
Surround right speaker
SB L
Surround back left speaker
SB R
Surround back right speaker
FP L
Presence left speaker
FP R
Presence right speaker
SWFR
Subwoofer
Selecting the recording source
Note