Filter
Top Products
146 En
Troubleshooting
After automatic setup
• If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run perform the automatic setup again.
• If warning message “W2” or “W3” appears, the adjustments are made, however the adjustment may not be optimal.
• Depending on the speakers, warning message “W1” may appears even if the speaker connections are correct.
• If error message “E10” occurs repeatedly, contact a qualified Yamaha service center.
Warning message Cause Remedy
See
page
W1:Out of Phase Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
Check the speaker connections for proper
polarity (+ or –).
17
W2:Over Distance The distance between the speaker and the
listening position is over 24 m (80 ft).
Bring the speaker closer to the listening
position.
—
W3:Level Error The difference of volume level among
speakers is excessive.
Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
—
Check the speaker connections. 17
Use speakers of similar quality.
—
Adjust the output volume of the subwoofer. 35
W4:SP Mismatch The result of “Wiring” checked by the
automatic setup is different from the
settings manually configured in
“Configuration”.
Manually configure the speaker settings in
“Configuration”.
93
“Wiring” has not been checked. Manually configure the speaker settings in
“Configuration”.
93
Notes