Filter
Top Products
108 En
Use this feature to save and recall up to six of your favorite
setting for the main zone. You can also save up to four of
your favorite settings for Zone 2, Zone 3 or Zone 4.
■ Saving by the
7
SYSTEM MEMORY
buttons
You can save the system settings stored in “Memory1” to
“Memory4” by pressing the corresponding
7
SYSTEM
MEMORY buttons.
Press and hold one of the 7SYSTEM MEMORY
buttons on the remote control for 4 seconds.
“Memory1 SAVE” (example) appears in the front panel
display, and then this unit saves the current system setting
to the corresponding memory number.
y
• If system settings are already stored in the selected memory
number, this unit overwrites the old settings.
• To save the system settings for Zone 2, Zone 3 or Zone 4, press
HZONE on the remote control repeatedly to select the desired
zone and then press and hold one of the 7SYSTEM
MEMORY buttons for 4 seconds. To save the system settings
for the selected zone, the zone should be turned on.
• This unit saves the parameters in the groups you select by using
the GUI menu when you save the parameters by using the
7SYSTEM MEMORY buttons.
■ Saving by the GUI menu operation
You can save the current system settings stored in
“Memory1” to “Memory6” by using the “System
Memory” menu in the GUI menu.
1 Set the operation mode selector on the
remote control to FAMP and then press
IMENU.
y
If the menu directory other than “Top Menu” (page 84) is
displayed, press and hold IMENU to display the top GUI
menu.
2 Press 9k / n repeatedly to select “Setup”
and then press 9h.
3 Press 9k / n repeatedly to select “System
Memory” and then press 9h.
4 Press 9k / n repeatedly to select the desired
zone and then press 9h.
5 Press 9k / n repeatedly to select “xxx Save”
and then press 9h.
“xxx” indicates the zone you selected in step 4.
6 Press 9k / n repeatedly to select the desired
memory number and then press 9ENTER.
The list of the parameter groups to be saved appears. Available
parameter groups vary depending on the selected zone.
y
• If system settings are already stored in the selected memory
number, this unit overwrites the old settings.
• To load the system settings with the 7SYSTEM MEMORY
button operation, use one of “Memory1” to “Memory4”.
7 Press 9k / n repeatedly to select the
parameter group and then press 9ENTER
to check or uncheck the box.
Check the boxes for the parameter groups to be saved.
For details on parameters to be saved, see
“Parameters to be saved” (page 109).
8 Press 9k / n / l / h repeatedly to select
“SAVE” and then press 9ENTER to save
the current system settings to the selected
memory number.
y
To cancel the operation, select “CANCEL” and then press
9ENTER.
9 Press IMENU to turn off the GUI menu.
■ Renaming the stored settings
1 Follow steps 1 to 4 in “Saving by the GUI
menu operation” (page 108).
2 Press 9k / n repeatedly to select “xxx
Rename” and then press 9h.
“xxx” indicates the zone you selected in step 1.
Saving and recalling the system settings (System Memory)
Saving the system settings
4
3
SYSTEM MEMORY
2
1
Main Save
Input/HDMI Out
Audio
Volume
SP Config
Video/Display Set
Others
SAVE
CANCEL