Filter
Top Products
123 En
Remote control features
ADVANCED
OPERATION
Use the supplied simplified remote control to make basic controls of this unit.
■ Setting the controlling zone of the
simplified remote control
Use this feature to set the controlling zone (page 127) and
remote control ID (page 130) of the simplified remote
control.
Setting the remote control ID
• ID1: Press and hold l (left cursor) and 1 for 3
seconds.
• ID2: Press and hold l (left cursor) and 2 for 3
seconds.
Setting the controlling zone
• Main zone: Press and hold h (right cursor) and 1 for 3
seconds.
• Zone 2: Press and hold h (right cursor) and 2 for 3
seconds.
• Zone 3: Press and hold h (right cursor) and 3 for 3
seconds.
• Zone 4: Press and hold h (right cursor) and 4 for 3
seconds.
■ Replacing the battery in the simplified
remote control
Change the battery when the operation range of the
simplified remote control decreases.
• Insert the battery according to the polarity markings
(+ and –).
• If the batteries run out, immediately remove them from the
simplified remote control to prevent an explosion or acid leak.
• If a battery starts leaking, dispose of it immediately. Be careful
not to let the leaking battery acid touch your skin or clothing.
• Before inserting new batteries, wipe the compartment clean.
• Dispose of batteries according to your regional regulations.
Simplified remote control
INPUT
MUTE
SYSTEM MEMORY
41 32
POWERSTANDBY
STATUS MENU
ENTER
SUBMENU
RETURN DISPLAY
VOLUME
STANDBY
Sets the selected zone to the
standby mode.
☞ P. 31, 127
SYSTEM MEMORY
Save or recall the system
settings.
☞ P. 108
INPUTl / h
Select the input source.
☞ P. 42
POWER
Turn on the power.
☞ P. 31, 127
VOLUME +/–
Adjust the volume level.
☞ P. 42
MUTE
Mutes the audio output.
☞ P. 44
Remove the insulation sheet before using the remote
control.
These buttons function as
well as the following
identical buttons on the
main remote control (when
the operation selector mode
is set to FAMP).
8STATUS
9k / n / l / h
9ENTER
0RETURN, SUBMENU
IMENU
KDISPLAY
Notes
Use a straight
pin to remove
the cover.
Replace the
battery with a
new CR2025
battery.
Close the
cover.