Filter
Top Products
E-86
REMOTE CONTROL FEATURES
■ Recording extra commands
There are two extra commands you can record in a macro:
• Source switching
To record a device action that includes a source switching com-
mand, open the Device menu, hold down the right button (labeled
“ACTION”) and tap the component to which you want to switch.
• Ending with a component control panel
To end a macro with the display of a component, open the Device
menu, hold down the left button (labeled “DEVICE”) and tap the
component you want.
■ Editing macros
You can edit any macro you have recorded.
1
1
Open the macro group that contains the macro.
2
2
Switch to the Edit mode via at the bottom of the
touch screen.
3
3
Tap the macro you want to edit.
The contents of the macro appear.
4
4
Edit the macro.
You can move or delete listed commands or record new
commands.
You can also add delays to the macro (for example, to insert a
short pause between turning on a component and sending
commands to it, allowing the component to warm up).
1 Tap .
2 Tap
or to decrease or increase the length of the delay.
3 Use
and to move the delay to the right position in the
sequence.
5
5
Press the left button to close the macro.
A confirmation screen appears that enables you to save or
cancel the macro.
6
6
Tap .
The macro is ready for use.
■ Organizing macros into groups
You can create as many macro groups as you like. Each group can
contain up to 25 macros.
1
1
Open any macro group.
2
2
Switch to the Add mode via at the bottom of the
touch screen.
You can create a new group, copy an existing group, or restore
a previously-deleted group.
•
: You add a new group in which you can
record new macros.
• : You copy a group and its macros and use
the copy to create new macros.
• : You restore a deleted group and reuse the
macros.
3
3
Tap .
You see a touch screen on which you can create and edit macro
groups. The new group is added to the Macro menu.