Filter
Top Products
E-77
ADVANCED
OPERATION
English
REMOTE CONTROL FEATURES
Working with modes
When you operate your components, the remote control is in the Use mode. For actions other than operating (like programming buttons,
recording macros, adding components, and so on),
you have to switch to the appropriate mode:
For operating components.
For learning commands from other components. *
1
For recording macros and setting timers.
For labeling buttons and commands. *
1
For adding new components.
For deleting buttons, components and macros. *
1
For changing the order in a menu.
For defining brands using the remote control’s database. *
2
■ Switching to another mode
1
1
Tap at the bottom of the touch screen.
The Mode menu pops up.
2
2
Tap the mode you want to use.
The label of the active mode appears on the top center of the
touch screen.
You can now work in the selected mode.
■ Hiding the Mode menu
To prevent accidental changes to the remote control interface and
commands, you can hide the Mode menu.
1
1
Make sure the remote control is in the Use mode.
2
2
Touch and hold the remote control icon for a few
seconds.
The first setup panel appears.
3
3
Scroll down to the second setup panel.
4
4
Tap .
The mode menu icon
is crossed out.
5
5
Tap the remote control icon.
The remote control switches to the Use mode.
Note
• Repeat steps 1 to 5 to turn the Mode menu back on.
*1: These actions cannot be made on the RECEIVER and TUNER. To make these actions, copy the RECEIVER and TUNER (see page
__) and make actions on the copied one.
*2: You can define brands other than YAMAHA for the RECEIVER and TUNER. However, you cannot operate this unit after defining the
other brands. If you want to operate this unit, reset the RC code to “Yamaha-6” for the RECEIVER, and “Yamaha-1” for the TUNER.