Filter
Top Products
E-34
SPEAKER MODE SETTINGS
This unit has seven SPEAKER SET items in the SET MENU that you must set according to the number of speakers in your configuration
and their size. The following table summarizes these SPEAKER SET items, and shows the initial settings as well as other possible settings. If
the initial settings are not appropriate for your speaker configuration, change the settings in the SET MENU.
■ Summary of SPEAKER SET items 1A through 1G
Item
1A CENTER SP
1B MAIN SP
1C REAR L/R SP
1D REAR CT SP
1E LFE/BASS OUT
1F FRONT EFCT SP
1G MAIN LEVEL
Cautions
• When you select 6CH INPUT as the input source, settings of “1 SPEAKER SET” on the SET MENU do not apply (except for “1G MAIN
LEVEL”).
• When the digital signals with over 96 kHz sampling frequency are input, only the “1G MAIN LEVEL” setting is effective.
Description
Selects the output mode according to whether or not a center speaker is being used and its
performance.
Selects the output mode according to the performance of the main speakers.
Selects the output mode according to whether or not rear L/R speakers are being used and
their performance.
Selects the output mode according to whether or not a rear center speaker is being used and its
performance.
Selects the speaker according to use for LFE signal output and low bass signal.
Selects the output mode according to whether or not front effect speakers are being used.
Selects the main speaker level.
Control value (default
setting indicated in bold)
LRG/SML/NONE
LARGE/SMALL
LRG/SML/NONE
LRG/SML/NONE
SW/MAIN/BOTH
YES/NONE
Normal/–10dB
■ Mode setting
Adjustment should be made with the remote control.
1
6
3,4,6
4,5
2
2
1
1
Tap on the Home menu to open the RECEIVER
control panels.
2
2
Tap ( or repeatedly) to open the
SET MENU control panel (page 7/8).
3
3
Select “1 SPEAKER SET” on the SET MENU.
Tap
or to display the SET MENU on the video
monitor. Tap
or repeatedly to select “1 SPEAKER
SET” on the SET MENU.
4
4
Enter the setting mode.
Tap or to enter the setting mode. The current setting is
shown on the front panel display and the video monitor. Select
item (1A – 1G) to be set by tapping or .
5
5
Change the setting.
Tap
or to change the setting for the selected item.
6
6
Close the SET MENU.
Tap
or repeatedly until the DSP program name
appears to close SET MENU or tap
and select one of
the DSP program.