Filter
Top Products
E-20
DVD
D–TV
/LD
SAT
MONITOR
OUT
FRONT
IN
FRONT
OUT
P
R
/C
R
L
FM ANT
75Ω
UNBAL.
–GND
TUNER
AM
ANT
■ Connecting an MD recorder/tape deck
Note
• To connect the OPTICAL (COAXIAL) output jack for an MD
recorder with this unit, you can use any of the OPTICAL
(COAXIAL) IN jacks by changing the setting for “8 I/O ASSIGN-
MENT” on the SET MENU (see page __).
CONNECTIONS
AUDIOAUDIODIGITAL VIDEO
VIDEO
DVD
PHONO
GND
CD
S VIDEO
LRR L
CABLE
SAT
IN
VCR 1
OUT
IN
VCR 2
OUT
D–TV
/LD
MAIN
1
CD–R
IN
(PLAY)
3
OUT
(REC)
4
MD/TAPE
IN
(PLAY)
3
OUT
(REC)
4
OPTICAL
OUT
COAXIAL
IN
MD/
TAPE
6
CD–R
8
CD
7
CD–R
5
CABLE
4
DVD
3
CD
2
LD
LD
RF
(AC–3)
1
ANALOG AUDIO
IN
ANALOG AUDIO
OUT
OPTICAL IN
MD recorder/tape deck
■ Connecting a turntable
These jacks are for connecting a turntable with an MM or high
output MC cartridge. If you have a turntable with a low output MC
cartridge, use an inline boosting transformer or MC-head amplifier
when connecting to these jacks.
Caution
• The GND terminal does not electrically ground the turntable. It
simply reduces noise in the signal. In some cases, you may hear
less noise if you do not connect to the GND terminal.
Ground
AUDIOAUDIODIGITAL VIDEO
VIDEO
DVD
PHONO
GND
CD
S VIDEO
LRR L
CABLE
SAT
D–TV
/LD
1
N
3
COAXIAL
IN
CABLE
4
DVD
3
CD
2
LD
LD
RF
(AC–3)
1
AUDIO OUT
Turntable
Connecting the antennas
Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength.
Connect each antenna correctly to the designated terminals.
Ground (GND terminal)
For maximum safety and minimum
interference, connect the antenna
GND terminal to a good earth ground.
A good earth ground is a metal stake
driven into moist earth.
AM loop antenna (included)Indoor FM antenna
(included)
A properly installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality, an
outdoor antenna may improve the quality. Consult the nearest
authorized YAMAHA dealer or service center about the outdoor
antennas.
■ Connecting the indoor FM antenna
Connect the included indoor FM antenna to the FM ANT 75Ω
UNBAL. terminal.
■ Connecting the AM loop antenna
1
1
Set up the AM loop antenna, then connect it.
2
2
Press and hold the tab to insert the AM loop antenna
lead wires into the AM ANT and GND terminals.
3
3
Orient the AM loop antenna for the beat reception.
Notes
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.