Filter
Top Products
E-9
INTRODUCTION
English
CONTROLS AND FUNCTIONS
■ Installing batteries in the remote control
1
1
Slide the battery door off the back of the remote
control.
2
2
Insert 4 supplied batteries as indicated on the bottom
of the battery compartment.
3
3
Slide the battery door back on.
After a few seconds, the remote control set up automatically
and beeps twice to indicate that it is ready to use.
Cautions
• Insert the batteries in the correct direction by aligning the + and –
marks on the batteries with the polarity illustrations (+ and –)
inside the battery compartment.
• Change the batteries periodically.
• Do not use old batteries together with new ones.
• Do not use different types of batteries (such as alkaline and
manganese batteries) together. Read the packaging carefully as
these different types of batteries may have the same shape and
color.
• Do not use rechargeable batteries.
• If the batteries have leaked, dispose of them immediately. Avoid
touching the leaked material or letting it come into contact with
clothing, etc. Clean the battery compartment thoroughly before
installing new batteries.
■ About changing batteries
When batteries are running low, the low battery icon flashes at
the center top of the display. Replace the batteries as soon as
possible to ensure perfect performance.
Note
• The remote control retains all settings when the batteries have
discharged or when you remove and replace them. You will need
only to reset the clock.
■ Using the remote control
The remote control transmits a directional infrared beam. Be sure to
aim the remote control directly at the remote control sensor on the
main unit during operation.
Cautions
• When the sensor is covered or there is a large object between the
remote control and the main unit, the sensor cannot receive
signals.
• The sensor may not be able to receive signals properly when it is
exposed to direct sunlight or a strong artificial light (such as a
fluorescent or strobe light). In this case, change the direction of
the light or reposition the main unit to avoid direct lighting.
• Handle the remote control with care.
• Do not spill water or other liquids on the remote control.
• Do not drop the remote control.
• Do not leave or store the remote control in the following types of
conditions:
1 high humidity or temperature such as near a heater, stove or
bath
2 dusty places
3 in places subject to extremely low temperatures
STANDBY
/ON
INPUT MODE
INPUT SELECTOR
VOLUME
30° 30°
Approximately 10 m (33 feet)
Remote control