Filter
Top Products
E-38
SPEAKER OUTPUT LEVELS
This section explains how to set the speaker output levels using the test tone generator. The “TEST DOLBY SUR.” is for balancing the
output levels of the six speakers required for surround sound systems. The “TEST DSP” is for balancing the front effect speakers with the
main speakers for the DSP sound field programs.
■ Before you begin
1 Set BASS, TREBLE and BALANCE on the front panel
to the center position.
2 Turn off BASS EXTENSION.
Cautions
• Since this unit cannot enter the test mode while headphones are
connected to this unit, be sure to unplug the headphones from the
PHONES jack when using the test tone.
• If the headphone is connected while “TEST DOLBY SUR.” or
“TEST DSP” is being used, the testing mode will be cancelled.
BASS
TREBLE
LR
BALANCE
BASS
EXTENSION
■ Display (on the remote control) to be used
Before you begin, go to the PARAMETER control panel following
the steps below.
1
1
Tap on the Home menu to open the RECEIVER
control panels.
2
2
Tap ( or repeatedly) to open the
PARAMETER control panel (page 8/8).
1
2
2