Filter
Top Products
E-81
ADVANCED
OPERATION
English
■ Labeling a button
1
1
Navigate to the panel containing the button you want
to label.
2
2
Switch to the Label mode via at the bottom of
the touch screen.
3
3
Tap the button you want to label.
The display shows a “virtual auto-zooming” mini-keyboard.
The button you want to label is displayed above the keyboard.
Note
• There are some buttons you cannot label. If you tap a button
you cannot label, you will hear a short buzz.
4
4
Edit the label.
• To delete a character, press the right button (labeled “DEL”).
• To enter a character, tap the keyboard near the character you
want to use.
The keyboard zooms in, allowing you to tap exactly the
character you need.
• To enter a space, tap the lower left corner of the keyboard.
When the keyboard zooms in, tap the empty key.
• For capital letters and symbols, press the left button (labeled
“SHIFT”) repeatedly to display the keyboard you want.
After you tap the character, the keyboard zooms out. Repeat
this action for each character.
Notes
• You can zoom out again without tapping a character by
pressing the right button (labeled “ZOOM”).
• Symbols cannot be entered if the point of characters used in
the label are too small.
5
5
Tap to save the changes and return to the
previous panel, or tap
to return to the previ-
ous panel without saving changes.
6
6
Label all the other elements you want and return to
the Use mode via
.
Labeling elements
The following elements can be labeled:
• Control panel buttons
• Components, macro groups and timer groups
• Macros and timers
• The left/right buttons labels
To label control panel buttons, macros, timers and the left/right buttons labels, go to “Labeling a button”. To label components, macro groups
and timer groups, go to “Labeling a component”.
You cannot label buttons on the second and third Home menu panel directly. You must label them via the Device menu.
REMOTE CONTROL FEATURES
■ Labeling a component
1
1
Switch to the Label mode via at the bottom of
the touch screen.
2
2
Tap the device tab to open the Device menu.
3
3
Touch and hold either the remote control’s left or
right button (labeled “DEVICE”) and tap the compo-
nent you want to label.
Even when you want to label the currently active component,
you must tap it in the Device menu.
The display shows a “virtual auto-zooming” mini-keyboard.
The button you want to label is displayed above the keyboard.
4
4
Complete steps 4 to 6 described in “Labeling a
button”.