Filter
Top Products
DU6675 DLP Projector - User's Manual
25
Connecting to the Control Equipment
The projector has the following control port for connecting to the control equipment:
3D sync signal
transmitter (IR)
• HDBaseT/LAN (Network control): The projector supports network control via LAN/
HDBaseT terminal. LAN and HDBaseT share the port. If only network control is used,
you can connect the LAN on the projector to PC or through the local network. Refer to
the Remote Communication Guide for more detail information.
• RS-232 (RS-232 control): The projector can be controlled by RS-232 command via
connecting the projector to PC or control system through the standard 9-pin serial
cable. Refer to the Remote Communication Guide for detail information.
• Wired remote control: If the projector cannot receive the IR signal from the remote
control due to the overly long distance or obstacles, you can connect the cable to the
IR remote control or the external IR transmitter (optional) via the WIRE port to expand
the working range of the remote control.
• 3D Sync Out: Connect to 3D IR sync signal transmitter.
Note:
• If the wired remote control cable or the external IR transmitter is inserted to the incorrect port, such as
Trigger, the remote control or the IR transmitter may be damaged. Make sure whether the port is correct.