Filter
Top Products
DU6675 DLP Projector - User's Manual
21
Turning Off the Projector
Once the projector is no longer required, it is important to shut it down correctly to avoid
damage or unnecessary wear and tear to the projector.
Note:
• Do not unplug the power cable from the wall outlet or projector when the projector is powered on. Doing so
may cause damage to the AC IN connector of the projector and (or) the prong plug of the power cable. To
turn off the AC power supply when the projector is powered on, use a power strip equipped with a switch
and a breaker.
Refer to the following guide to shut down the projector.
1. Press the POWER button on the control
panel or OFF button on the remote
control once, the Power Off window
displays.
2. Press the POWER button again on the
OSD control panel or remote control
to confirm power off. The cooling fans
continue to operate and the power LED
flashes orange. The cooling fans stop
operating when the projector turns off.
3. The projector enters Standby mode
when the power LED lights orange.
4. Press the Main Power switch to the off
position (O) to turn off the projector.
About Direct Power Off
The projector has a feature called "Direct Power Off". This feature allows the projector to
be turned off (even when projecting an image) using a power strip equipped with a switch
and a breaker.
Note:
• Before using Direct Power Off, be sure to allow at least 20 minutes immediately after turning on the
projector.