Tascam CC-222MK CD Player User Manual


 
TASCAM CC-222MKIII 29
Note the following when loading tapes:
1 Useyourngerorapenciltoturnthecassette's
hubandtakeupanyslacktape.
NOTE
Avoid touching the tape. Fingerprints attract dust
and dirt.
2 PresstheEJECTkeytoopenthecassettecom-
partmentdoor.
3 Loadthecassettetapewithitsopenedgefacing
down.
4 Gentlyclosethecompartmentdoor.
NOTE
The cassette holder cannot be opened during
recording or playback.
If the power has been switched off during play or
recording, ejecting the cassette may be impossible.
In such a case, switch the power on and press the
EJECT key again.
7- Cassette operations
Continuous tape/CD playback
1 Loadthetapeasdescribedaboveintotheunit.
Loadthediscrecordedsidedownwardsusingthe
OPEN/CLOSE key.
2 PresstheCD-TAPE CONT PLAYkey.
3 PresseitherofthePLAYkeysofthetapedeck,or
the PLAYkeyoftheCDdeck.
Playbackwillstartontheappropriateunit.
Whenplaybackreachestheendofthedisc,or
theendofthetapeasdeterminedbytheREV
MODEsetting,playbackstartsontheotherunit.
NOTE
Media (tape or disc) can be changed in the unit that
is not playing.
4 Tostopplaybackandcancelthemode,pressthe
CD-TAPE CONT PLAYkeyagain.
NOTE
The cassette deck and CD deck can be used to
play back through different outputs, or the LINE
OUTPUTS 2 jacks can be used for both disc and
tape playback. However, note that if both are play-
ing, the cassette takes priority (the disc will not
be heard through these outputs). Disc playback is
always through the LINE OUTPUTS 1 jacks.
Playback operations
WARNING
If you are monitoring using headphones, first adjust
the level control to low on the unit, then connect to
the POHNES jack before playing back. This will pre-
vent any possible damage to your hearing.
1 Set the REV MODEswitchtotherequiredtape
mode.
Ä Single-sided playback
Ë One side, then the other side, then stop
ä One side, then the other side, then the first side
again, etc.
Also,checktheMONITORswitchissettoTAPE.
2 Loadapre-recordedcassettewithitsopenedge
facingdownandsideAfacingtowardyou.
3 Set the DOLBY NRsystemonoroff.
4 PresseitherPLAYkeytostartplayback.
5 Adjustthevolumewiththeamplier’svolume
control.
6 Tostopplayback,presstheSTOPkey.